Mitsubishi Electric LGH-150RX3-E [10/12] Caution

5. Set the Lossnay M-NET remote controller address.

Set the Lossnay M-NET remote controller address using the rotary switches

SW1 and SW2 on the front of the Lossnay M-NET remote controller.

■ Setting range: 101 to 200

● Rotary switch SW1 indicates the tens column and SW2 indicates the ones

column. In addition, 100 is automatically added to the setting as shown

below.

The address is set to 01 when the Lossnay M-NET remote controller is

shipped from the manufacturer.

CAUTION:

The address must be set if the Lossnay M-NET remote controller is to be used

as a part of a multi-unit system. Set the address according to its position in

the system. In addition, refer to page 59 for more information concering the

setting of the addresses.

6. After setting the Lossnay M-NET remote controller address, attach the

Lossnay M-NET remote controller cover.

When attaching the Lossnay M-NET remote controller cover, set the top of the

cover onto the two top hooks and then push in the at the bottom of the cover

until it snaps into place.

If the bottom of the cover is attached first, the top of the cover cannot be

attached. Forcefully pushing in the top of the cover to attach it may break the

hooks.

SW1

SW2

Rotary switches

Rotary switch setting 01 – 99 00

Lossnay M-NET remote controller address 101 – 199 200