Mitsubishi Electric LGH-100RX4-E [11/12] Registering the lossnay unit with the lossnay

72

14.3 Registering the Lossnay Unit with the Lossnay

M-NET Remote Controller

Initial registration mode operation

A Lossnay unit must be registered with the Lossnay M-NET remote controller in a group arrangement. Register a Lossnay unit

using the initial registration mode as shown below. In addition, the initial registration mode can be used to search for a Lossnay

unit registered to the group or to delete a registration.

Setting Procedure

FILTER

3

Press to select the address of the Lossnay unit that you wish to register with this Lossnay M-NET remote controller.

After the button is pressed once, the Lossnay M-NET remote controller address and then the Lossnay unit

address is displayed. Afterwards, each press of the button increase the Lossnay unit address by 1 as shown

below. Holding down the button changes the address more quickly.

[

101

][

–––

][

001

][

002

]

. . .

the wiring are correct.

In the case of LGH-150/200RX

for each of the circuit boards, and register both of those addresses at the remote control.

5

After registering, hold down both and for more than 2 seconds to end the initial registration mode and the nor-

mal display appears.

FILTER