Home
Главная
Polaris
Электрический Проточный Водонагреватель
VEGA P 5.5
Инструкция по эксплуатации Страница: 21

Polaris VEGA P 5.5 Инструкция по эксплуатации онлайн [21/25] 20081

There are common installation problems:

Problem Reason and solving method

When the water is very hot,

but only for a short time,

and then the water becomes

very hot again briefly but

for a short time also.

It means that the heater has been installed incorrectly and that

the outlet is being obstructed by some tap or other object.

The tap must be located at the inlet of the heater! Use only

the parts supplied with the heater at the outlet!

The heater heated the water

as expected, but only for a

short time and not again.

The protective fuse blew out, because it was unsuited to the

power of the heater installed.

The heater is not heating. Check to be sure that only parts supplied with the heater are

attached at the outlet! Make sure that the tap at the inlet is a

regular one, not a brass ball faucet/level tap, so that the water

flow can be finely controlled.

Common malfunctions that occur after prolonged, normal use of the heater

The water is very hot The water temperature can be reduced at the outlet by one of

the following actions:

 the water temperature can be lowered by pressing one of

the "supply choice buttons", going from a maximum supply

to a lower level;

 the water-flow can also be increased by means of the

water tap located at the heater's inlet; more "holes" can be

opened in the shower head to let more water pass through.

 The filter located at the inlet to the heater should also be

cleaned.

The water is very cold. The water temperature can be increased at the outlet by one

of the following actions:

 the water temperature can be raised by pressing one of the

"supply choice buttons", going from a minimal supply to a

higher level;

 the water-flow can also be decreased by means of the

water tap located at the heater's inlet;

 fewer "holes" can be left open in the shower head to let

less water pass through

The water is spraying out of

the shower head too slowly

and/or in the wrong

direction (not into the

shower).

The "holes" in the shower head must be cleaned.

VII. Unit cleaning

 Before cleaning, unplug the unit.

 Wipe it with soft wet cloth. Don’t use solvents or abrasives.

 Don’t scrape the body with hard instruments.

Polaris VEGA P 5.5 Инструкция по эксплуатации онлайн [21/25] 20081

Содержание

Похожие устройства