Smeg BQ61S [14/19] Pan diameters

Smeg BQ91S [14/19] Pan diameters
Instructions for the User
35
10.STANDARD ACCESSORIES
9.3 Switching on
To check that the burners have ignited, hold one of your hands about 10 cm above the grids: you should
feel a gradually increasing amount of heat.
When lighting the rapid or auxiliary burners, keep the knob pressed down for about 2 seconds to
allow the thermocouple to heat up. The burner may go out when the knob is released: this means that
the thermocouple has not warmed up enough. Repeat the operation, keeping the knob pressed down for
longer.
If the burners have not ignited after several attempts, wait 5 minutes before attempting to light the
appliance again. This pause is necessary to allow any gas which has built up inside the appliance to
disperse. If no flame is obtained even after numerous attempts, contact your nearest authorised service
centre.
9.3.1 Electronic burner ignition
The burner it controls is shown next to each knob (See “The control panel” on page 32). To light the
flame, simply press the knob and turn it anti-clockwise to the minimum flame value and press the
ignition button. To adjust the flame, turn the knob to the zone between the maximum ( ) and the
minimum ( ) settings. To turn off the burner, turn the knob back to the OFF position.
9.3.2 Manual burner ignition (for internal burners only)
The barbecue's internal burners can be lit using a long match or with the aid of a piezoelectric kitchen
lighter. Lift the plate above the burner to be lit, place the lit match or piezoelectric lighter next to the
burner and turn its control knob to the maximum flame setting. Take great care not to allow large
amounts of unburnt gas to escape. If the burner has not lit after 3 seconds, turn the knob to OFF and
repeat the operation a few minutes later.
When lighting more than one burner by hand, the most efficient method is to light the central burner as
described above and then turn the knobs of the burners next to the one just lit to use the inter-ignition
function. Burner inter-ignition is possible if one or more adjacent burners are lit.
Before removing the grid to light the burner by hand, make sure that it is not hot.
If the burner does not light even in manual mode after a few attempts, call the after-sales service.
9.4 Pan diameters
Rapid Burner pans with diameter from 18 cm to 26 cm can be used on this burner.
Auxiliary Burner pans with diameter from 12 cm to 16 cm can be used on this burner.
Pans of different sizes might put the user’s safety at risk and adversely affect the appliance’s
performance, as well as damaging its exterior.
Food warmer shelf: useful for keeping food hot after cooking.
Hang this shelf on the back of the barbecue, above the burners.
Fit it into the holes provided in the back panel.
Additional optional accessories are also available from
our authorised service centres.

Содержание

Скачать