Canon CLI-8C Инструкция по запрвке картиджей онлайн [11/12] 10148

S a v e M o n e y a n d I m p r o v e Y o u r P r i n t i n g

MIS Associates Inc 2901 Auburn Rd Auburn Hills, MI 48326 800-445-8296

http://www.inksupply.com Fax: 248-289-6013 Email: sales@inksupply.com

4. Use some black electrical tape and tape over the exit port on the bottom of the

cartridge. This is so ink will not leak out when you fill the sponge section or the

reservoir section.

5. Using the syringe, inject ink into the sponge area until full. Move the needle around

into different spots in the sponge to get it totally saturated. Leave the hole into

the sponge compartment open, do not cover or block. Next, inject ink into the

reservoir area until almost full. Leave just a little air space, so it does not overflow.

This is just to keep everything from getting messy.

6. Make sure the area where the ball was, is clean and free of any chips or plastic

film. Press the black rubber replacement ball (MIS-HPBALL) into the hole where

the original ball was located. Just use your finger nail to seat the ball so it is flush

with the surface of the cartridge. Don't go too far or it will get pushed inside the

cartridge. Do not cover or plug the hole you drilled in the sponge compartment. This

is the air vent and it must be left open. Remove tape from bottom exit port.

Note: If the ball does not make a perfect air tight seal, then ink will drip out of

the cartridge at the exit port until empty. If this happens, see step 7.

7. If the cartridge is dripping, let it drip into a cup or dish until it stops. Don't keep

the exit area, where the ink comes out in contact with any paper or cloth because it

will wick all of the ink out. If it has stopped dripping, put it back in the printer and

run a cleaning cycle. If it continues to drip for a long time, you may have an air leak

around the rubber ball. Make sure the ball is not damaged or gouged. Put a new one

in if it is damaged. If you damaged the ball seat when pushing it in or cut it

somehow, it will leak air. If you can't get a good seal with the ball, add some hot