Canon CLI-8C Инструкция по запрвке картиджей онлайн [12/12] 10148

S a v e M o n e y a n d I m p r o v e Y o u r P r i n t i n g

MIS Associates Inc 2901 Auburn Rd Auburn Hills, MI 48326 800-445-8296

http://www.inksupply.com Fax: 248-289-6013 Email: sales@inksupply.com

melt glue around it to help the sealing process. If you need more of the rubber

balls (MIS-HPBALL), you can order them from the accessory page.

8. The next time you are ready to refill you can reuse the rubber ball if you carefully

spear it from the side and remove it with a bulletin board stick pin. Don't push

down on the ball or it will pop into the reservoir area. This is not a problem, it just

means you will have to have another ball to seal the hole. If you are careful you can

reuse the rubber ball 3 or 4 times.

9. As an alternate procedure you can drill into the reservoir area, inject the ink and

then use hot melt glue to seal the hole AIR TIGHT. If you don't like drilling, then

try a heated paper clip to melt a hole in the reservoir. Hold it with pliers and heat

with a lighter or torch.

If your cartridge drips for a long time after refilling, this means there is an air

leak in the reservoir section.