CONEL SPECTRE v3 ERT — руководство по подключению и настройке маршрутизатора [3/4]

Превью страниц Страница 3 / 4

START GUIDE

3. Power Cable Connection

The router requires DC power supply from +10 to +60 V DC. The router has

a built-in protection against reverse polarity without signaling.

Connect power cable to the connector labeled as PWR on the front panel of

the router (see figure below).

4. Ethernet Cable Connections

Ethernet cable has to be connected to ETH0 or ETH1 connector on the front

panel (see figure below). Ethernet cable is used for configuration and communication

with the router.

If the router is equipped with any additional interface, relevant cable has to be

connected to the connector in the upper left corner of the front panel (type and label

depends on the interface). Wiring of connector pins is described in user manual of

the router. This manual can be found on the Conel website in the download section:

http://www.conel.com/download. Please, use the following login information:

Username: ConelFreeDownload

Password: coneldownload

Configuration Settings over Web Browser

Status monitoring, configuration and administration of the router can be done

using web interface which is available after inserting IP address of the router to your

web browser. Default IP address is 192.168.1.1. Configuration is allowed for user

"root" with initial password "root". Attention, it is necessary to use HTTPS protocol

for secure communication over a network!

Detailed description of the router configuration via router web interface can be

found in Configuration manual, see Conel website: http://www.conel.com/download.

Please, use the following login information:

Username: ConelFreeDownload

Password: coneldownload

Power supply

connector

Ethernet

connector