CONEL UR5i v2 — настройка сетевого интерфейса через веб-браузер [24/106]

Превью страниц Страница 24 / 106

1. CONFIGURATION OVER WEB BROWSER

Continued from previous page

Item Description

IP address Fixed set IP address of network interface ETH.

Subnet Mask IP address of Subnet Mask.

Bridged

• no – router is not used as a bridge (default)

• yes – router is used as a bridge

Media type

• Auto-negation – The router selects the speed of communication

of network options.

• 100 Mbps Full Duplex – The router communicates at 100Mbps,

in the full duplex mode.

• 100 Mbps Half Duplex – The router communicates at 100Mbps,

in the half duplex mode.

• 10 Mbps Full Duplex – The router communicates at 10Mbps,

in the full duplex mode.

• 10 Mbps Half Duplex – The router communicates at 10Mbps,

in the half duplex mode.

Default Gateway IP address of router default gateway. When entering IP address of

default gateway, all packets for which the record was not found in the

routing table, sent to this address.

DNS server IP address of DNS server of router. Address where they are forwarded

to all DNS questions on the router.

Table 14: Conﬁguration of network interface

Default Gateway and DNS Server items are used only if the DHCP Client item is set to a

value disabled and if the Primary or Secondary LAN is selected by Backup routes system as

a default route (selection algorithm is described in section 1.17 Backup Routes).

There can be only one active bridge on the router at the moment. Only parameters DHCP

Client, IP address and Subnet Mask can be used to conﬁgure bridge. Pr imary LAN has got

higher priority in this respect when both interfaces (eth0, eth1) are added to the bridge. Other

interfaces (wlan0 – wiﬁ) can be added (or deleted) to (from) existing bridge at any moment.

Moreover, the bridge can be created on demand of such interfaces but not conﬁgured by their

respective parameters.

DHCP server assigns IP address, gateway IP address (IP address of the router) and IP

address of the DNS server (IP address of the router) to the connected clients. If these values

are ﬁlled-in by the user in the conﬁguration form, they are preferred.

DHCP server supports static and dynamic assignment of IP addresses. Dynamic DHCP

server assigns clients IP addresses from a deﬁned address space. Static DHCP assigns IP

addresses that correspond to the MAC addresses of connected clients.