CONEL CR10 v2 [3/4] Start guide

START GUIDE

Power cable connection

The router requires DC power supply from +10 to +30 V DC. The router has a built-in

protection against reverse polarity without signaling.

Connect power cable to PWR connector on the front panel of the router and tighten

locking screws (see figure below).

Ethernet cable connection

Ethernet cable is connected to ETH connector (see figure below). Ethernet cable is

used for configuration and communication with router.

If expansion ports are assembled, cable is connected to port PORT1 or PORT2. Wiring

of pins for expansion ports are described in manual of corresponding expansion port. These

manuals can be found on the Conel website: http://www.conel.com/download. Please, use

the following login information:

Username: ConelFreeDownload

Password: coneldownload

Power

cable

Ethernet

cable