Home
Главная
Timberk
Конвектор
tec.pf10 le 1000 in
Инструкция по эксплуатации Страница: 8

Timberk tec.pf10 le 1000 in [8/24] Maintenance

www.timberk.com • electric convector heater

The unit must be cleaned regularly to remove dust and dirt from external

surfaces, since it affects its operation efficiency and temperature

parameters of room heating. Prior to preventive operations, switch off

the unit and disconnect it from electric mains, let it cool down, then wipe

its surface by a soft and slightly damp duster. It is not recommended to

use detergents for washing, including materials with abrasive elements.

Prevent damaging the unit by sharp objects, since scratches on a painted

surface may cause rusting.

Rear surface of the convector must also be regularly cleaned from dust and

dirt. For this purpose it is necessary to dismount the unit from the bracket,

and after cleaning it is necessary to return it to the initial position.

Preventive cleaning should be performed regularly to maintain technical

condition of the convector and preserve its external appearance for a long

time.

1. On/off button of the device

2. Mode select button power

3. Button lock function «Child lock»

4. Button set timer

5. Function buttons

Rules of the use of the remote control.

1. To work correctly when using the remote control, always point the IR

emitter signal directly at signal receiver on the front panel convector.

2. Avoid direct sunlight on the remote control

3. Do not drop the remote control and do not expose it to moisture

4. Promptly replace the batteries in the remote control

5. If not supposed to use the remote control for a long time, then be sure

to remove the batteries to prevent oxidation of contact elements remote

control.

Battery installation (Fig.8)

1. Open the cover of the battery, pushing the locking lever to the right and

pull the compartment down. Remove the tray for a battery.

2. Insert the battery type CR2025

3. Set the tray for the batteries in the remote control

IMPORTANT!

Management of the convector is possible using the

remote control supplied with the device. Remote

control allows to control all the functions of the

convector: enable or disable the device, select the

power mode of the heating temperature adjustment,

timer setting to disable, enable or disable the «Child

Lock».

5 seconds with no operation.

6. Timer function of the convector turning on

After you press « » under standby condition, then «0» flicker(means 0

hour)+« » (means hour)light, then you press « » or « » button, heater

will turn on after 1 or 24 hours

7. Interlock function «Child lock»

7.1. To lock the control convector simultaneously press buttons « » and

« »

7.2. On the display indicator « »

7.3. To unlock the control panel push buttons « » and « ».

Remote control of the convector series TEC.PF8 LE…IN,

TEC.PF9LE…IN, TEC.PF10 LE...IN

Fig. 7

8. MAINTENANCE

Timberk tec.pf10 le 1000 in [8/24] Maintenance

Содержание

Похожие устройства