Yamaha PSR-500m [6/47] This section contains information about setting up your psr

Содержание

PREPARATION This section contains information about setting up your PSR400 PSR 500 and preparing to play Be sure to go through this section carefully before using your PSR 400 PSR 500 POWER SUPPLY Your PSR 400 or PSR 500 will run either from batteries or an optional power adaptor Follow the instructions below according to the power source you intend to use When batteries are used the sound of the PSR 400 PSR 500 may be distorted at high vol ume levels This is because the power of the amplifier is reduced when batteries are used CAUTION Never interrupt the power supply e g remove the batteries or unplug the AC adaptor dur ing any PSR 400 PSR 500 record operation Doing so can result in a loss of data Using Batteries srvie SPLIT VOCE BÊAT The PSR 400 PSR 500 is initially supplied with a set of batteries Depending on storage conditions the supplied batteries may not last as long as a fresh set When the batteries need to be replaced batt will appear on the MULTI DISPLAY When this display appears the PSR 400 PSR 500 will not operate and the power must be turned off while either the batteries are replaced or an AC adaptor is connected Internal data will be retained for up to about 10 minutes while the batteries are changed or an AC adaptor is connected When the batteries fail replace them with six 1 5 V SUM 1 D size R 20 or equivalent batteries as follows 1 Open the battery compartment cover located on the instrument s bottom panel and remove the old batteries 2 Insert the six new batteries being careful to follow the polarity markings on the inside of the compartment 3 Replace the compartment cover making sure that it locks firmly in place If fresh batteries or an AC adaptor are not immediately available it may be possible to use the PSR 400 PSR 500 for a little while longer by turning the power off and then on again and playing at a low volume setting Caution 1 When the batteries run down replace them with a complete set of six new batteries NEVER mix old and new batteries 2 Do not use different kinds of batteries at the same time 3 To prevent possible damage due to battery leakage remove the batteries from the instru ment if it is not to be used for an extended period of time Using An Optional AC Power Adaptor Plug the DC output cable from an optional Yamaha PA 5 AC Power Adaptor into the DC IN jack on the rear panel of the PSR 400 PSR 500 then plug the AC cable of the Power Adaptor into a convenient wall AC power socket The internal batteries are automatically disconnected when an AC Power Adap tor is used Use ONLY a Yamaha PA 5 AC Power Adaptor to power your instrument from the AC mains Other adaptors may be damaged by use with the PSR 400 PSR 500 and they may even cause serious damage to your PSR 400 PSR 500 4

Скачать
Случайные обсуждения