Moxa IMC-P101-M-SC [7/14] Grounding the moxa industrial media converter

- 7 -

STEP 2:

Mounting the Moxa PoE Media Converter on the wall

requires 4 screws. Use the IMC, with wall mount plates

attached, as a guide to mark the correct locations of the 4

screws. The heads of the screws should be less than 6.0

mm in diameter, and the shafts should be less than 3.5

mm in diameter, as shown in the figure at the right.

NOTE

Test the screw head and shank size by inserting

the screw into one of the keyhole shaped

apertures of the Wall Mounting Plates, before it

is screwed into the wall.

Do not screw the screws in all the way—leave a space of

about 2 mm to allow room for sliding the wall mount

panel between the wall and the screws.

6.0 mm

3.5 mm

STEP 3:

Once the screws are fixed in the wall, insert the four screw heads through the

large openings of the keyhole-shaped apertures, and then slide Moxa PoE

Media Converter downwards, as indicated below. Tighten the four screws for

added stability.

Grounding the Moxa Industrial Media

Converter

Grounding and wire routing help limit the effects of noise due to

electromagnetic interference (EMI). Run the ground connection from the

ground screw to the grounding surface prior to connecting devices.

ATTENTION

This product is intended to be mounted to a well-grounded

mounting surface such as a metal panel.