MartinLogan ML-75R Руководство пользователя онлайн [9/28] 170121

3. Twist matched wires together, then cap each bundle with a wire nut.

4. Fill wire nuts with silicone.

5. Speaker cable can now be buried, where burying is required.

Connecting 1-Channel of Amplification (Left OR Right) to a Single Speaker (figure 6)

In this connection method, the input wires from the speakers will be joined together so

that the entire speaker can be driven from one channel of amplification (Left OR Right).

1. Connect the (+) amplifier terminal to both the right red AND left red (+) speaker

input wires.

3. Connect the (–) amplifier terminal to both the right black AND left black (–) speaker

input wires.

4. Twist matched wires together, then cap each bundle with wire a nut.

5. Fill wire nuts with silicone.

6. Speaker cable can now be buried, where burying is required.

Installing the Security Stake and Cable (optional)

1. Without moving the speaker out of position, lay the speaker on its back so that the

bottom is exposed (figure 7a).

2. Feed the looped end of the security cable (the end without spike attached) through

the factory-installed eyelet on the speaker's bottom (figure 7b).

3. Feed the spike through the loop in the cable (figure 7c).

3. Pull gently on the cable until it is snug around the eyelet.

4. Using a rubber mallet, drive the security stake into the ground close to where the

speaker will sit. It must be completely under the surface of the ground. Give cable

a gentle tug to make sure stake is firmly planted in the ground (figure 7d).