Moxa V2616A-C8-W7E [16/44] Attention

V2616A Hardware Manual Hardware Connection Description

3-3

Connecting the Power

Connect the 24 to 110 VDC power line with M12 connector to the V2616A computer. If the power is supplied

properly, the Ready LED will glow a solid green after a 25 to 30 second delay.

Grounding the Unit

SG: The Shielded Ground (sometimes called Protected Ground

) contact is the central pin

of the power input connector. Connect the SG wire to an appropriately grounded metal

surface.

Connecting Data Transmission Cables

This section describes how to connect V2616A embedded computers to a network and serial devices.

Connecting to the Network

Two 10/100/1000 Mbps Ethernet ports using M12 X-coded connectors are located on the rear panel..

ATTENTION

There is risk of damage to the M12 X-coded cable due to improper installation or removal.

Before you attach an M12 X-coded cable to an Ethernet port on the V2616A, read the instructions carefully.

The M12 X-coded cable is designed with locking mechanisms

to prevent pin misalignment. Make sure that you

properly align the indicator and notches when connecting the cable.

Do NOT insert the cable into a port with excessive force.

The following figure shows the Ethernet port location on the rear panel.

Follow the steps below to connect an M12 X-coded cable:

1. Obtain an M12 X-coded cable.

The following table shows the Ethernet connector and cable options. For more information, please contact

your local Moxa sales representative.

Model Name Type Description

CBL-M12XMM8PRJ45-BK-100-IP67 Cable and connector 1-meter X-coded M12-to-RJ45 Cat-5E UTP

Gigabit Ethernet cable, 8-pin male M12

connector, IP67-rated.