Autel Autolink AL301 Руководство пользователя онлайн [13/109] 171291

 Not all the above messages will be displayed unless protocol of

the vehicle being tested is the last one—the ISO9141 protocol.

They will stop appearing after the vehicle protocol is detected

and a confirmation message of ―XXX Protocol‖ is displayed.

 If a “LINK ERROR!” message shows up, turn the ignition

off for about 10 seconds, check if the Scan Tool’s OBDII

connector is securely connected to the vehicle’s DLC, and

then turn the ignition back to on. Repeat the procedure

from step 5. If the “LINK ERROR” message does not go

away, then there may be problems for the Scan Tool to

communicate with the vehicle.

6. Wait for the main menu to come up after a brief overview

displaying the scanning results with the total number of DTCs

and the overall I/M Monitor Status.

7. Select “DTC” from the main menu by pressing the ENTER

button.

 If there are no Diagnostic Trouble Codes retrieved, the display

will indicate “NO CODES”.

 If there are any Diagnostic Trouble Codes, then the total number

of the Fault Codes followed by that of the Pending Codes will

be reported on the display.