M-Audio Delta TDIF Инструкция по эксплуатации онлайн [18/58] 19006

ON THE MAC: The Delta Control Panel must be placed on the hard

drive by dragging the application from the Drivers disk. Once this is

done, an alias may be created by highlighting the Delta Control Panel on

the hard drive and pressing the Apple key+M. Then, this alias may be

dragged to the desktop. Double clicking either will launch the control

panel. Once the Delta Control Panel software has been opened, you will

see the main panel and its several tabs. To display a desired page, click on

its tab. Below are functional descriptions of each page. Though most of

the descriptions are Windows based, the functions are identical unless

otherwise indicated. Within each section you will find the necessary

name changes for using the Delta Control Panel “ON THE MAC.”

NOTE: When using a music software program that is ASIO capable,

launch the Delta Control Panel software from within that program.

There will be a button in the ASIO or Audio setup page that will

allow you to do so. Some of the control panel functions will be

controlled from within that program, such as master clock setting

and sample rate, so it is desirable to launch the music program

first, and then the Delta Control Panel from the the program’s

“launch” or “control panel” button. Without the music program

open however, it is okay to open the Delta panel from your desktop

or other location.

Monitor Mixer Page

The Monitor Mixer is the first page that appears when the Delta Control

Panel is opened, and controls the digital mixer built into the Delta TDIF’s

PCI controller chip. As described in previous sections, the output of this

mixer may be assigned to the OUT1/OUT2 TDIF outputs, and to the

Analog and S/PDIF outputs simultaneously (this selection is made in the

Patchbay Router page). At the same time, the mixer outputs may be

recorded in stereo by software by selecting “Mon. Mixer”as the audio

source for a given track.