M-Audio Delta TDIF Инструкция по эксплуатации онлайн [42/58] 19006

6. Within your recording software, select "SP/ANA In Delta-TDIF," as

the audio input device. The Delta input appears as a stereo pair, or as

left and right inputs (see the section, “Using the Delta TDIF with your

Music Software Application”).

7. Start your software recording and then start your DAT material

playing. You should be able to hear the DAT material through your

sound system.

8. Once you have recorded your tracks, set the music software’s output

port to WavOut SP/ANA. Go into the Delta Control Panel

“Patchbay/Router” page, and set the H/W Out SP/ANA column to

play “WavOut SP/ANA. This will connect your software outputs to

the Delta TDIF’s Analog and S/PDIF hardware outputs, allowing you

to monitor playback from the analog outs. Rewind, and playback

your recorded material.

Transferring from Computer to DAT, monitoring with

DAT

1. Connect the Delta TDIF’s S/PDIF Out to the DAT’s coaxial S/PDIF

Input using a good quality digital cable.

2. Connect the DAT analog outputs to some type of amplified sound

system. The sound system should be equipped with speakers or

headphones. You could, conceivably, continue to monitor via the

Delta TDIF’s analog outputs, since the signal sent to the S/PDIF out is

duplicated at the analog outs. However, it is often better to monitor

the DAT, since any problems occuring at the DAT will be heard when

monitoring the DAT.

3. Because you will be playing back at the recorded sample rate, you will

want to set the Delta TDIF’s master clock to use the internal crystal.

Do this by opening the Hardware Settings page of the Delta Control