M-Audio Delta TDIF Инструкция по эксплуатации онлайн [51/58] 19006

NOTE: When resolving conflicts between PnP and non-PnP

devices, it is recommended to re-adjust the resource settings of

the non-PnP device first. Typically, Windows is only aware of the

resource settings of the installed PnP devices and has no

information available to it for adjusting the PnP devices’ resources

around those of the non-PnP devices. The exceptions to this are

when: (1) a non-PnP device has a true Windows 98/95 driver

written for it, (2) the BIOS setup allows reserving an IRQ for a

legacy device as opposed to a PnP device, or (3) resource

requirements for the non-PnP device have been manually entered

into the Windows Device Manager. In these cases Windows is

aware of the non-PnP device’s resource requirements.

One of the quickest ways to change the resources assigned to a PCI card

like the Delta TDIF is to merely relocate the card to another PCI slot. With

the computer’s power off, remove the Delta TDIF from its current PCI

slot, move it to another available PCI slot, and turn your computer back

on. More often than not, this will change the IRQ assignment of the Delta

TDIF when you re-enter Windows. After returning to Windows, follow

the steps outlined in the "Verifying Windows Driver Installation" section

of this manual. It might take more than one PCI slot relocation to find an

open IRQ.

If relocating your card to another PCI slot does not cure the Delta TDIF’s

conflict(s), then you must do some further investigation to determine the

exact nature of the conflict(s). Again, go to the Windows Device

Manager, highlight the Delta TDIF or other devices with conflicts and

click the "Properties" button at the bottom of the Device Manager

window. This will open the properties page for that device. Select the

"Resources tab" in order to view the resource assignments, plus possible

conflicts. You may learn more about a conflict by highlighting each item

one-by-one (done by clicking on them, or scrolling through the list using

your keyboard cursor keys) and examining the "Conflicting resource list:"

at the bottom of the box.

Sometimes it is possible that a resource problem is not showing up in the

conflicting resource list or as a yellow exclamation point in the Device

Manager. If you have any doubt about the configuration of your device

(or just want to double-check), you can view all of the devices and their

assigned resources by highlighting "Computer" at the top of the Device

Manager list and clicking the Properties button. This will allow you to

view a list of assigned IRQ numbers on the left, and the associated

devices on the right. If a number does not show up in this list, it means

that it is available for use. Look also for IRQs that are shared by more

than one device. While the Delta TDIF may share an IRQ with some

devices, not all devices are capable of sharing IRQs. An entry that reads