Moxa ioLogik E1241 [8/8] Atex information

- 8 -

Load Factory Default Settings

There are three ways to restore the ioLogik E1200 to factory default

settings.

1. Hold the RESET button for 5 seconds.

2. In the ioSearch utility, right-click on the ioLogik device to be reset and

select Reset to Default.

3. Select Load Factory Default from the web console.

Modbus Address Table

Consult the user’s manual for the ioLogik’s Modbus address, or find the

default address of the I/O channels in the web console by clicking

User-defined Modbus Addressing  Default Address.

Active OPC Server Connection

Connect the ioLogik E1200 to an Active OPC Server by following the steps

below:

1. Disable the user-defined Modbus address function.

2. Download Active OPC Server Lite utility from Moxa's website and

install it.

3. Install from Web console  Active OPC Server Settings  AOPC

& I/O Settings; specify the IP address where the Active OPC Server

is installed. Specify the I/O channels that need to be added to Active

OPC Server Lite. Submit the settings and then Save/Restart.

4. From Web Console  Active OPC Server Settings  Create

AOPC Tag, click the Create Tag button.

5. Launch Active OPC Server Lite from the Windows Start menu: Start

 Programs  MOXA  IOServer  ActiveOPC  ActiveOPC.

Save configurations before exiting Active OPC Server Lite.

NOTE

A “load” in a circuit schematic is a component or portion of the

circuit that consumes electric power. For the diagrams shown in

this document, “load” refers to the devices or systems connected

to the remote I/O unit.

ATEX Information

1. Certificate number: DEMKO 13 ATEX 1210600X

2. Certification string: Ex nA nC IIC T3 Gc

3. Standards covered:

EN 60079-0:2012+A11:2013, EN 60079-15:2010

4. These products are to be installed in an ATEX Certified IP54

enclosure and accessible only by the use of a tool.

5. These products are for use in an area of not more than pollution

degree 2 in accordance with IEC 60664-1.