Aten VS0202 [7/12] Single stage

- 7 -

Hardware Installation

Before you Begin

Single Stage

Setting up the Video Matrix Switch is simply a matter of plugging

in the cables. Refer to the installation diagram on the next page

(the numbers in the diagram correspond to the numbered steps)

and do the following:

1. Use a high density HDB-15 male/female VGA cable to con-

nect the computer’s video port to any available video input

port on the Video Matrix Switch.

2. Use a male/male audio cable to connect the computer’s

speaker port to the audio input port that corresponds to the

video input port you connected in step 1.

3. Connect the monitor to any available video output port on the

Video Matrix Switch.

4. Connect the speakers to the audio output port that

corresponds to the video output port you connected in step 3.

Note: Repeat steps 1 - 4 for any other ports you wish to set

up.

5. Plug the power adapter that came with the Video Matrix

Switch into an AC power source, then plug the power

adapter cable into the switch’s Power Jack.

6. Power on the attached equipment.

1. Make sure that the power to all the devices you will

be connecting up has been turned off.

2. Make sure that all devices you will be connecting

up are properly grounded.

VS-0202_0204_manual.fm Page 7 Friday, March 3, 2006 3:51 PM