Ada aerotemp [5/26] Aero temp

AeroTemp

OPERATION INSTRUCTIONS

1. Unscrew the battery lid according to the arrows direction, remove insulation pad under the battery and place a CR2032 button bat-

tery according to the polarity indication, then put back the battery lid.

2. Press WCI button to power on the unit and the default status is wind speed and environment temperature mesurement .

3. Wind speed measurement: pull out the impeller protection cap to make the fan vertical to wind direction. Current wind speed will

be displayed on the up line of the screen.

4. Adjustment of wind speed display mode: in normal state, press SET/HOLD button to change display mode. Press each time to

switch from real-time, MAX, MIN, AVG in turns and display corresponding signs and no sign indicator for real time mode.

5. Adjustment of wind speed unit: in normal state, press UNIT button, the wind speed unit flashes. then press SET/HOLD button to

switch the units (m/m, m/s, km/h , ft/m, m/h, knots). Each press will make corresponding unit flashes. Press UNIT button twice to exit

this mode. The units don’t flash any more and return to normal state.

6. Adjustment of temperature unit: in normal state, press UNIT button twice continuously to enter this mode. At this time, the tempera-

ture unit flashes. Then press SET/HOLD button to switch between °F and °C. Each press can make corresponding temperature unit

flashes. Press UNIT button again to exit this mode. The temperature units don’t flash any more and return to normal state.

7. The screen hold function: in normal state, hold SET/HOLD button for 2 seconds to lock the screen content and “HOLD” sign ap-

pears. Press this buttton again to release lock and return to normal state.

Notes: During hold period, if battery lack of power, low battery indicator will appear on the screen.

8. Environment temperature and wind chill temperature display: in normal state, environemnt temperature displayed in below line.

Press /WCI button to display wind chill in below line and WCI sign. Press again to return to environment temperature display and

WCI sign disappears.

Note: Wind chill is only used for the wind speed >1.34m/s ((4.8km/h).

9. Power off the unit: hold /WCI button for more than 2S to power off the unit.