Fubag SIROCCO Keramik 50T [5/11] Troubleshooting
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Fubag SIROCCO Keramik 50T [5/11] Troubleshooting

Fubag SIROCCO Keramik 50T [5/11] Troubleshooting
www.fubag.ru
Omperator's anual
--4
THERMOSTAT INSTRUCTIONS
А(0.
At first turn the thermostat to “Max” and let the heater operate with full power input. When the room
temperature reaches the required value, turn the thermostat to left until it switches off.
The thermostat will then switch on and off automatic to control the room temperature according to
the preset value and keep the room temperature constant.
To turn off the heater after use - toggle switch to the second position, and give the work to cool the
heating element is not less than 2 minutes. Then switch the mode switch to the first position, and
remove the connector plug from the socket.
djustable hermostat o ontrol he oom emperature rom o MAX)
-
-
-
ttctrt ft
5 aintenance
6
.M
. Troubleshooting
Before cleaning the appliance, disconnect it from the socket and let it cool down.
The enclosure is easily to get dirty, wipe it often with soft sponge. For very dirty parts, wipe with a
sponge dipped in < 50 C water and mild detergent, then dry the heater enclosure with clean cloth.
Be careful not to let the water enter the appliance inner.
Don t splash water onto the heater never use solvent like gasoline, isoamyl acetate, toluene etc to
clean the heater, in order to protect the enclosure.
Clean the coupler, dry and pack it in a plastic bag.
When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in
the packing box and store it in a dry, ventilated place.
-
-
°
-'
-
-
PROBLEM POSSIBLE CAUSE TREATMENT
The plug is loose, bad
connection
Pull out the plug, check the
connection of the plug and socket
The heater does not
operate, even when it
is plugged in and the
switch, thermostat are
switched on
No power in socket outlet Insert the plug in a proper socket
The input voltage is too high
or too low
Use power supply according to the
rating on the label
The heating element
glowing
The air inlet grill is blocked
Keep the heater far way from articles
like curtain, plastic bag, paper and
other things which can cover the inlet
or can be easily cover on the air inlet
The switch was not put at
heating setting
Turn the switch to heat setting
The thermostat operated
Turn the thermostat and listen if there
is open/close voice. If there is no click
and the thermostat is not damaged,
the heater will automatic switch on
when the appliance cooled down
The appliance didn’t
heat up, only
ventilator worked
The self resetting cut-out
operated
Turn the heater off and inspect the
blockage of inlet or outlet. Disconnect
the plug and wait at least 10 minutes
for the protection system to reset
before attempting to restart the heater
Abnormal noise
The appliance is not stands
upright
Put the heater on a level surface

Содержание

Похожие устройства

Скачать