Главная
Skipped breadcrumb items
NC380
Руководство пользователя Страница: 3

Главная
STATUS
NC380
Руководство пользователя Страница: 3

STATUS NC380 — основные правила безопасности и советы по использованию инструмента [3/7]

Превью страниц Страница 3 / 7

3. SPECIFIC SAFETY RULES

SPECIFIC SAFETY RULES

Always switch off the power tool before to placing it down.

Before connecting a tool to a power source ensure that the voltage supply is the

same as that specied on the nameplate of the tool.

• During operation the cutting head gets hot. Do not touch the cutting head during

operation and immediately after that; they may be extremely hot. You may get

serious burns. Always wear thickly padded gloves when replacing the tool.

•

4. FEATURE

FEATURE

1. Speed-Deceleration Casing

2. Switch

3. Screw Sleeve

4. Cutting Head

1. Cutting blade

2. Blade part

3. Up-blade block

4. M3x12 hexagonal screw

5. Down-blade block

6. Screw sleeve

1. Cutting head

2. M4 hexagonal screw

ASSEMBLY AND ADJUSTMENT

Switching on/ off

Switching on: push the ON/OFF switch (2) forward to the gear case , until its front

end will sag, thus xing itself .

Switching off: press the back lifted end of the ON/OFF switch (2) and release it to

move back in its initial position.

Additional nozzle

This tool also has additional nozzle for curve cutting. For disassmebly, unscrew the

screw (4) and pull off the nozzle with spanner (16 mm).

5. ASSEMBLY AND ADJUSTMENT

6. WORK ADVICES

WORK ADVICE

Fasten the material to be cut to the work table. Push the slider of the ON/OFF

switch (2) forward to switch the machine on.

CAUTION: Never feed the nibbler into the material being cut if the motor is not

rotating.

Hold the tool vertically to the surface of the machined material during operation.

Tilting the machine in any direction is not recommended and it shall decrease the

efciency, besides the die might be damaged.

For curve cutting with small arc radius, it is necessary to rotate the machine

gently in order to avoid bending and deformation of the die.

To begin cutting in the centre of the material, rst make a round opening for the

die to be inserted into.

Coat the cutting line with machine oil to increase the punch and die service life

and cutting speed.

To cut steel sheet, use machine oil, used for machining metals.

To cut Aluminium and non-ferrous metals, use mixture of naphtha and turpentine

with 7:3 ratio.Lubricate the die and punch with machine oil every 10 min of

operation.

Excessive fast feeding of the nibbler shall result in considerable overloading the

die, punch and motor.

Quality cuts can be achieved until the punch cutting edge is sharp enough. The

worn punch shall be replaced with a new one. Replace the worn die and punch

in due time.

CAUTION: The die and punch must not be reground.

CAUTION: Disengage the cutting head from the material while the motor is still

running. Otherwise the punch may be damaged.

STATUS NC380 — основные правила безопасности и советы по использованию инструмента [3/7]

Содержание

Похожие устройства