Cisco sb spa112-xu [5/12] Using the web based configuration utility

Cisco SPA100 Series Analog Telephone Adapters 5

Configuration and Management of the ATA

You can use the web-based configuration utility to set up your ATA. You

also can use the built-in Interactive Voice Response (IVR) system.

Using the Web-Based Configuration Utility

STEP 1 Connect your computer to the same subnet as the ATA. For

example, if the ATA is connected to a LAN port on your router, also

connect your computer to a LAN port on your router.

Note: On SPA122, you can connect your computer to the

ETHERNET (Yellow) port of the ATA.

STEP 2 Power on your computer.

NOTE: Make sure your computer’s Ethernet adapter is set to obtain

an IP address automatically. For more information, refer to the Help

for your operating system.

STEP 3 Start a web browser on your computer.

STEP 4 In the Address bar, enter the IP address of the ATA.

• SPA112: Use the ATA’s IVR or your router’s configuration utility

to find the dynamically assigned IP address of the ATA. For

information about the IVR, see Using the IVR for

Administration, page 6.

• SPA122: In the Address bar, enter: 192.168.15.1

Note: 192.168.15.1 is the default local IP address of the ATA.

STEP 5 To log in for the first time, enter the default username, admin, and

the default password, admin. The password is case sensitive.

STEP 6 Enter the Connection Type and settings required by your Internet

Service Provider. Types include DHCP (the default option),

Static IP, and PPPoE (required for most DSL service). After

entering these settings, click Submit to establish your

Internet connection.

STEP 7 Use the menus to configure your settings, as needed. For more

information, see the ATA Administration Guide. (Documentation

links are provided in Where to Go From Here, page 11.)