Telefunken TF-CSRP3444 [6/14] Instruction manual
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Telefunken TF-CSRP3444 [6/14] Instruction manual

Telefunken TF-CSRP3444 [6/14] Instruction manual
6
Instruction manual
6
repeatedly FOL+ or FOL- button on the RC
to select a folder.
• Select a desired track by using /
buttons on the unit or or buttons
on the RC.
• Press PROGRAM (PROG) button again to
confirm. The set will advance to next memory
position, the display will show “P02”. Repeat
two steps described above to enter additional
memories into the program if necessary.
• After the maximum of 99 tracks (or less)
have been selected as described above, press
USB button on the unit or on the RC to
start playing the programmed tracks.
• The “PROGRAM” symbol will remain on
to indicate that you have saved a program-
memory (sequence).
• To check the program you stored, after
the programming is completed, in stop mode
press PROGRAM (PROG) button, then press
repeatedly button on the unit or
button on the RC to see all programmed track
numbers.
• The program memory will be cleared when
you press STOP button twice, open the disc
compartment door or turn off the disc player or
power supply.
Good quality sound is guaranteed only
when playing licensed MP3 discs.
USB playback
• This unit is equipped with a USB socket
that can accept and play MP3 files stored on
standard USB flash (compatible with USB
versions 2.0) up to 16 Gb.
• To use USB drives for MP3 playback, slide
the function switch to CD/MP3 position. Insert
the USB drive into the USB port and press and
hold USB button on the unit or on the RC
until the display shows “USB”.
• All operations with files contained in USB
are the same as operations with MP3 discs.
Always switch off the unit or change
mode to CD before removing a USB flash
drive, to prevent damage to your USB device.
Note: Although this product is fully
compatible with USB 2.0 standard formats,
a small percentage of USB flash drives
might not be readable, due to those device
manufacturers non-compliance with the full
(official) USB standards. FAT/FAT32 file
systems are supported.
iPod/iPhone docking
• Open the iPod jack compartment cover
and connect your iPod or iPhone to the jack.
Be careful, the jack can be easily damaged.
Ensure the connection is good for a better
contact.
• Set the function switch to AUX position.
The battery of the connected device will be
automatically charged by the power of this unit.
• When the device is connected, this unit
will serve as amplifier and speaker for music
played in the connected device. Rotate VOL
regulator on this unit to adjust volume. All
playback operations are performed by the
controllers of the connected device.
• If you connect an external device through
the AUX input and iPod at the same time, the
iPod/iPhone docking will not function.
Only 30pin external devices are
supported, newer models require a special
connector (not included).
“Dynamic Bass Boost” system
For increased bass at all volume levels,
press BASS button for an emphasized bass
sound. Press the button again to disable the
function. When the function is activated, BASS
indicator will light up in red.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and

Содержание

Похожие устройства

Скачать