Home
Главная
Vitek
Пылесосы
VT-1891 R
Инструкция по эксплуатации Страница: 5

Vitek VT-1891 R [5/24] English

E N G L I S H

cushions, but for collecting dust from furniture

surface as well, the pile on the brush (24) pre-

vents damage of polished furniture surface.

Using the dustbag

1 cloth dustbag and 3 paper dustbags are sup-

plied with the unit.

• Open the dustbag compartment lid (16) by

pressing the clamp (17).

• Take the dustbag holder (23) and pull it

to remove dustbag holder (23) from the

clamps (22).

• To install the dustbag (26) back to its place,

insert the dustbag holder (23) into the

clamps (22).

• Close the dustbag compartment lid (16).

Note: Always make sure that the dustbag (26)

is installed properly before closing the dustbag

compartment lid (16).

USING THE VACUUM CLEANER

Safety measures

• Do not use the vacuum cleaner near hot

surfaces, ashtrays and in the places where

inflammable liquids are stored.

• If the suction power of the vacuum cleaner

decreases rapidly while cleaning, switch the

vacuum cleaner off immediately and check

the telescopic pipe and the flexible hose for

obstruction. Switch the vacuum cleaner off,

then unplug it, remove the obstruction and

only after that continue cleaning.

USING THE VACUUM CLEANER

Attention! Always switch the vacuum cleaner

on only with the dustbag (26) and inlet (21)

and outlet (12) filters installed. Always

make sure that the filters are installed pro-

perly.

• Before using the unit, unwind the power cord

to the required length and insert the power

plug into the mains socket.

• The yellow mark on the power cord indicates

the maximum cord length. Do not unwind the

power cord further than the red mark.

• Press the ON/OFF button (9) to switch the

vacuum cleaner on.

• During the operation you can control the

suction power using the suction power con-

trol (10).

• After room cleaning switch the vacuum

cleaner off by pressing the ON/OFF button

(9) and unplug the unit.

• To wind the cord press the cord winding but-

ton (11), hold the winding cord with your hand

to avoid its whipping and damage.

CLEANING AND CARE

• If full dustbag indicator (13) turns «red» during

operation, replace the paper dustbag or clean

up the cloth dustbag.

• Before cleaning or replacing the dust-

bag (26) switch the vacuum cleaner off and

unplug it.

• Provide that the inlet filter (21) and the outlet

HEPA filter (12) are always clean, because the

overall performance of the vacuum cleaner

depends on it; clean the filters no less than

3-4 times a year, and more often at severe

obstruction.

Cleaning the inlet filter (21)

• Switch the vacuum cleaner off and unplug it.

• Open the dustbag compartment lid (16) by

pressing the clamp (17). Remove the dust-

bag (26).

• Take the inlet filter (21) and remove it from the

holders (20) pulling it upwards.

• Wash the inlet filter (21) with warm water, dry

thoroughly and install it into the filter hold-

ers (20).

• Install the dustbag (26) back to its place.

• Close the dustbag compartment lid (16).

Cleaning the outlet HEPA filter (12)

• Switch the vacuum cleaner off and unplug it.

• Remove the outlet filter grid (7) by pressing

the clamp (8) and remove the HEPA filter (12).

• Wash the HEPA Filter (12) under slightly warm

water jet. Do not wash the HEPA filter (12) in a

dishwashing machine.

• Dry the HEPA filter (12). Do not dry the HEPA

filter with a hairdryer.

• Install the HEPA filter (12) back to its place.

• Install the outlet filter grid (7) back to its place.

Notes:

– Before installing the filters (12, 21) make sure

that they are dry.

– Do not dry the filters (12, 21) with a hairdryer.

Vacuum cleaner body

– Wipe the vacuum cleaner body with a soft,

slightly damp cloth and then wipe it dry.

– Do not immerse the body of the vacuum

cleaner, the power cord and the power plug

of the unit into water or other liquids. Provide

VT-1891.indd 5 03.12.2015 10:51:01

Vitek VT-1891 R [5/24] English

Содержание

Похожие устройства