Hyundai h-hv8-10-ui583 Инструкция по эксплуатации онлайн [8/48] 194812

Electric convector

WARNING!

The power outlet should be rated at least 10A for models with a maximum

capacity of up to 2000 W and at least 12 A for models with a maximum

capacity of 2500 watt

6. OPERATION

ATTENTION!

In order to increase the operational life of the convector is recom-

mended to note the order unit is switched oﬀ. Shutting down the output

without pre-cooling of the heating elements can cause overheating and

premature failure.

1. Inclusion

1.1 Connect the convector to the mains by inserting the plug into the outlet.

2. Selecting the heating power

2.1 Turn the knob in the heating mode position «I» to select low power heating.

2.2 Turn the selector knob to position the heating mode «II» to select the average heating power.

2.3 Turn the selector knob to position the heating mode «III» to select a high heating power.

3. Setting the temperature

3.1 Turn the thermostat knob clockwise until it stops. When the room temperature reaches the de-

sired level, turn the thermostat knob counter-clockwise to turn oﬀ the meter. Now the thermostat

will maintain the set temperature, periodically enabling and disabling convector.

4. Shutdown

4.1 Set the mode switch «OFF» and disconnect the appliance from the mains.

5. CONNECTING TO THE MAINS

1. Convector is designed for connection to the plug with single-phase ~220 V, 50 Hz.

2. Before connecting, make sure that the voltage is correct as speciﬁed on the nameplate with the

technical data of the device.

3. Convector when connected to the plug must comply with applicable electrical codes.

4. Electric outlet must be properly grounded. The receptacle must be rated for at least 10A.

Electrical plug and socket must always be kept dry to prevent electrical leakage. Regularly check

that the electrical plug is ﬁrmly connected to the outlet. Veriﬁcation is performed in the following

order: Insert the mains plug into the socket. Aer half an hour, turn oﬀ the convector and unplug

the power cord, check with the hand , whether the plug is not heated.

If the plug is heated to a temperature above 50 °C, in order to avoid damage, accidents, ﬁre, due

to poor electrical contact replace the socket with help of a specialist.