Upvel UP-316FEW — настройка агрегации ссылок и приоритетов в сетевых устройствах [42/52]

Превью страниц Страница 42 / 52

UP-308FEW / UP-316FEW

System Priority: A value that identifies the active LACP. The switch with the lowest value

has the highest priority and is selected as the active LACP peer of the trunk group.

Link Aggregation Algorithm: Select the algorithm of link aggregation. The available options are:

• MAC Src&Dst – Hash Algorithm based on Source & Destination MAC Address XOR result.

• MAC Src – Hash Algorithm based on Source MAC Address

The default setting is MAC Src&Dst.

Member: Select the ports that will be the members of link aggregation group. Default link

group 1 includes P1, P2, P3, P4. Default link group 2 includes P5, P6, P7, P8.

State: Disable / Enable port trunk. The default setting is Disable.

Type: Select port trunk type: Static or LACP (Dynamic). The default setting is LACP.

When the LACP Trunk type is selected, the following parameters can be configured. Please

note that the parameters of ports that belong to one link aggregation group should be the

same on both ends.

Operation Key: Range: 1~65535. Default Link Group 1: 1; Default Link Group 2: 2.

Time Out: Select Long Time Out or Short Time Out. The Long Time Out is approximately

30 seconds, the Short Time Out is approximately 3 seconds, however, the link partner of

other supplier may not use the same value. The longer time out then will be used.

Activity: Select whether the link group is allowed (Active) to automatically send LACP

packets or not (Passive). The default setting is Passive.

User Manual 42