Plustek SmartOffice SC8016U — как откалибровать сканер для точной цветопередачи [41/50]

CALIBRATING THE SCANNER

Calibrate the scanner if colors appear in areas that should be white, or colors of the

scanned image and the original vary a lot. This allows you to adjust and compensate

for variations that can occur in the optical component over time by its nature.

The following describes how to calibrate the scanner:

1. The Calibration Sheet, marked with an arrow on either edge at both sides, is

used specially for ADF Scanning calibration.

2. Insert the special calibration sheet into the ADF of the scanner, with an arrow

toward the scanner buttons.

Attention

Please insert the special calibration sheet

included with the scanner. Alternatively you may

also use any plain white sheet of paper sized in

A4 (216 by 297 mm) instead; however, the

calibration effect may be less good than the

special calibration sheet.

3. Click Start > All Programs > Your scanner model name > Calibration

Wizard.

(For Windows 8.1 users: Point your mouse cursor to the upper or lower

right corner of your screen to open the Charm bar. Click on the Start charm,

then click on the downwards arrow button in the lower left corner of the screen.

The Apps screen will be shown. Move your cursor to the right edge of the

screen to scroll right until you find Your scanner model name, and then click

on Calibration Wizard.)

4. Click Next from the Calibration Wizard that pops up and then click Calibrate

Now....

5. Click on the Start button to begin the calibration process.

6. The scanner pulls the calibration sheet through the scanner, which completes

this scanner calibration. After the calibration is complete, click OK and then

click Finish.