Home
Главная
Timberk
Инфракрасный Обогреватель
tch a1n 700
Инструкция по эксплуатации Страница: 6

Timberk tch a1n 700 Инструкция по эксплуатации онлайн [6/20] 201675

www.timberk.com • electric ceiling heater

1. Open the factory package and carefully remove the heater from it.

2. Take the set of fasteners.

3. Bend the bracket legs (Fig. 4.1) at angle about 90° (Fig. 4.2).

4. According to Figs. 1, 2 and Tables 3, 4, select the heater installation

place on the ceiling or ceiling structural elements with observation of

minimum distances from objects and minimum distance from the floor.

5. Install the brackets at distance from each other according to Fig. 1,

securing them using a chain or fasteners (fig. 4.3).

6. Suspend the heater on the brackets according to Fig. 4.4, first securing

on edge, then another. Make sure that screws are tightened firmly.

Connection to electric mains

1. The heater is designed for connection to the single-phase ~220-240V,

50Hz electric mains equipped with a grounding loop.

2. Before connection, make sure that specifications of the electric mains

at the connection point meet the parameters indicated on the appliance

nameplate.

3. The heater should be connected to the electric mains using a cable with

wire section at least 1.5 mm

. The electric mains should be equipped

with an automatic circuit breaker with rated current not less than 16A.

4. For connection of the heater to the electric mains, it is necessary to do

the following:

• remove the cover from the heater.

• cut a hole in the rubber seal.

• insert the electric cable to the heater.

• tightly fix the bare ends of the electric cable in the junction block of the

heater with screws in strict correspondence with marking on the block.

• reinstall the cover.

Infrared heater mounting

NOTE:

Depending on material and design of ceiling structural

elements, the heater is secured onto appropriate

fasteners chosen on basis of the strength condition.

Strength of the ceiling or structural elements, to which

the heater is secured, should be sufficient to endure

5-fold weight of the heater.

NOTE:

Instruction Manual, which can show and explain a way

of working modes for Remote Control Block, can be

found inside giftbox of Remote Control Block. Remote

Control Block is optional feature; you should buy it

separately.

WARNING!

After installation of the heater and before switching for

the first time, it is necessary to wipe the radiating board

with alcohol. After that, it is PROHIBITED to touch the

radiating board.

Fig.4

Timberk tch a1n 700 Инструкция по эксплуатации онлайн [6/20] 201675

Похожие устройства