Hitachi DS12DVF3 — инструкция по установке компонентов механизма [22/34]

Превью страниц Страница 22 / 34

--- 19 ---

(i) Note the direction of the groove when installing the Slide Ring Gear [17] so that the groove faces

toward the Motor [25].

(ii) Install the Front Case [9] and the Rear Case [14] together with the mark on the Front Case [9] aligned

with the mark on the Rear Case [14]. (See Fig. 15.)

(iii) Install Washer (B) [23] in the Rear Case [14] with the projections of Washer (B) [23] engaged with the

recesses in the Rear Case [14], and turn Washer (B) [23] clockwise until it can turn no further. (See

Fig. 14.)

Fig. 14

Recess

Projection

[23]

Fig. 15

With the ridge at the Shift Arm [16] facing the Motor [25] side, first install them on the unmarked side of the

assembly reassembled in step (b). Then insert the projections on the Shift Arm [16] into the holes in the

Rear Case [14] and make sure that the projections are fitted into the grooves in the Slide Ring Gear [17]

mounted within the Rear Case [14]. (See Fig. 15.)

(d) Install the Drill Chuck 10TLRK-N (W/O Chuck Wrench) [2].

Install the Drill Chuck 10TLRK-N (W/O Chuck Wrench) [2] using the special repair tool (J-292, Code No.

316-379) and secure it with the Special Screw (Left Hand) M5 x 27 [1].

(e) Install the Shift Knob [36] into the assembly reassembled in step (d).

When installing the Shift Knob [36] into the Shift Arm [16], note that the "LOW" mark on the Shift Knob [36]

faces the Motor [25] with the Shift Arm [16] engaged with the recess in the Shift Knob [36].

Hole

Ridge

[16]

Groove

Mark