Texas EC1400 Инструкция по эксплуатации онлайн [13/36] 206824

Use

This product is made for cutting lawn edges. All other use that is not specifically allowed in

this manual may lead to manage to the product or injury to the user.

Assembly

The product is fully assembled in the box. Always control all moving parts can move

without trouble.

Starting up and how to use

Cord routing

Always make sure that you route the cord away from the work area to prevent it from

coming near the blade of the edger. Lay your cable route before starting work. Start your

edger at the point nearest to the electrical socket, and then move away whilst working.

This will mean that the cord will be pulled through the area that has already been cut,

thereby keeping it out of danger of being cut through by the blade.

Switching on

Your TEXAS EDGER is fitted with a Lock-off button and a trigger switch to prevent

accidental operation of the tool.

To Tum the Edger "On", first depress the smal1 lock off button on the side of the handle

and squeeze the trigger switch. When the tool starts you can

release the smal1 lock button.

To Tum the EDGER "Ojf', Release the Trigger switch.

IMPORTANT. Do Not force the trigger switch without first pressing

the Lock Button.

Do Not tie or jam the trigger switch in the "On" position. The trigger

switch is designed to be held in the "On" position by your hand

only.

Take care when you tum the EDGER "On" that the cutter is in a safe position to operate.

Edge Guide

The edge guide is used when edging is required against a solid material like a paved

surface. It is important to ensure the edge guide is used in these conditions as the edge

guide will assist in preventing the blade from making direct contact with the paved surface.

To set the edge guide in the Down position, grasp the Edge Guide Control Knob and move

the knob sideways toward the centre of the edger and then push downwards.

The Edge Guide Control Knob should be returned to the upright position to lock the Guide

in the down position.

To set the edge guide in the Up position, grasp the Edge Guide Control Knob and move

the knob sideways toward the centre of the edger and then pull upwards to lift. The guide.

The Edge Guide Control Knob should be returned to the upright position to lock the Guide

in the raised position.