Crunch 214B [20/25] Connecting the power

1. Install the suction cups onto the bracket by fitting them into their holes.

2. Attach the bracket to windshield.

3. Attach Detector to bracket.

4. Bend bracket for correct detection angle (if necessary), do not use the

CRUNCH 214B to bend bracket.

5. Plug power cord DC12V into detector.

6. Plug power cord into cigarette lighter.

Cautions: Some new models of cars have a plastic safety coating which is

applied to the windshield. The suction cups may leave permanent marks on the

windshield once they are removed. Check vehicle owner's manual to see if your

car has the plastic safety coating.

Connecting the Power

The detector is designed to operate on most DC12V negative ground vehicle

electrical systems. The power cord provided with the detector has a cigarette

lighter socket plug at one end and a small connector at the other.

1. Insert the small connector into the jack on the side of the detector.

2. Insert the other end into the cigarette lighter socket of your vehicle.

If the detector does not operate when you turn it on, remove the adapter from

the cigarette lighter socket and carefully check the socket for debris. Also,

check the fuse in the adapter and your vehicle's fuse box.

Replacing the Fuse

If the detector CRUNCH 214B stops operating, the fuse in the cigarette lighter

plug might be blown. If it has blown, follow these steps to replace it:

1. To replace the fuse, unscrew the top of the plug.

2. Remove the fuse and check the fuse to see if it has blown. If it has, replace

it.

OPERATION

Power on and Self-Test

To turn the detector on, connect power and turn the On/Off volume control

away from you until it clicks.

When powered up, the detector sounds a distinctive tone for each signal and

flashes in sequence as a self-test. Then all display turn off except the ‘P’.