Crunch 211B Инструкция по эксплуатации онлайн [18/23] 23402

1.Use a damp cloth to thoroughly clean both the bottom of the detector and the

dashboard.

2.Peel off the tape's paper backing and apply the tape to the bottom of the detector.

3.Remove the paper backing from the other side of the tape and press the detector onto

the dashboard.

Windshield Mounting

The supplied windshield bracket and suction cups let you quickly mount the detector to

your vehicle's windshield.

Follow these steps to use mounting bracket kit.

1.Install the suction cups onto the bracket by fitting them into their holes.

2.Attach the bracket to windshield.

3.Attach Detector to bracket.

4.Bend bracket for correct detection angle (if necessary), do not use the CRUNCH 211B

to bend bracket.

5.Plug power cord DC12V into detector.

6.Plug power cord into cigarette lighter.

Cautions: Some new models of cars have a plastic safety coating which is applied to the

windshield. The suction cups may leave permanent marks on the windshield once they are

removed. Check vehicle owner's manual to see if your car has the plastic safety coating.

Connecting the Power

The detector is designed to operate on most DC12V negative ground vehicle electrical

systems. The power cord provided with the detector has a cigarette lighter socket plug at

one end and a small connector at the other.

1. Insert the small connector into the jack on the side of the detector.

2. Insert the other end into the cigarette lighter socket of your vehicle.

If the detector does not operate when you turn it on, remove the adapter from the cigarette

lighter socket and carefully check the socket for debris. Also, check the fuse in the adapter

and your vehicle's fuse box.

Replacing the Fuse

If the detector CRUNCH 211B stops operating, the fuse in the cigarette lighter plug might

be blown. If it has blown, follow these steps to replace it:

1. To replace the fuse, unscrew the top of the plug.

2. Remove the fuse and check the fuse to see if it has blown. If it has, replace it.

OPERATION

Power on and Self-Test

To turn the detector on, connect power and turn the On/Off volume control away from you

until it clicks.

When powered up, the detector sounds a distinctive tone for each signal and flashes in

sequence as a self-test. Then all display turn off except the ‘P’.