APC Smart-UPS SUA750RMI2U — инструкция по подключению и настройке источника бесперебойного питания [7/19]

Превью страниц Страница 7 / 19

1. Connect equipment to the UPS. Note: Do not connect a laser printer to the UPS. A laser

printer draws significantly more power than other types of equipment and may overload

the UPS.

2. Add any optional accessories to the SmartSlot.

3. Using a power cord, plug the UPS into a two-pole, three-wire, grounded receptacle only.

Avoid using extension cords.

100V/120V models: The power cord is permanently attached to the rear panel of the UPS. The

INPUT plug is a NEMA 5-15P.

230V models: The power cord is supplied by the customer. Connect ground leads to the TVSS

screw (optional). To make the connection, loosen the screw and connect the surge suppression

device’s ground lead. Tighten the screw to secure the lead.

4. Turn on all connected equipment. To use the UPS as a master ON/OFF switch, be sure all

connected equipment is switched ON. The equipment will not be powered until the UPS is

turned on.

5. To power up the UPS press the button on the front panel.

•

The UPS charges its battery when it is connected to utility power. The battery charges to

90% capacity during the first four hours of normal operation. Do not expect full battery run

capability during this initial charge period.

•

120V Models: Check the site wiring fault LED located on the rear panel. It lights up if the

UPS is plugged into an improperly wired utility power outlet. Refer to Troubleshooting in

this manual.

6. For additional computer system security, install PowerChute Smart-UPS monitoring software.

ASIC

ONNECTORS

Serial Port

USB Port

Power management software and interface kits can be used with the

UPS. Use only interface kits supplied or approved by APC.

Use an APC supplied cable to connect to the Serial Port. DO NOT use a stand-

ard serial interface cable since it is incompatible with the UPS connector.

Both Serial and USB Ports are provided. They cannot be used simultaneously.

TVSS Screw

The UPS features a transient voltage surge suppression (TVSS) screw for

connecting the ground lead on surge suppression devices such as telephone and

network line protectors.

When connecting grounding cable, disconnect the UPS from utility power.