Hyundai H-MS2300 [9/29] Radio operation

- 9 -

General operations

Press POWER ON/OFF button once to switch on the unit.

Press VOLUME +/VOLUME- buttons on the unit or VOLUME UP/VOLUME DOWN buttons on the

RC to increase and decrease the volume level.

Note: Sometimes, especially during listening to the radio, you may notice a "click-click-click"

(repeating) sound when you are increasing or decreasing the volume. This is a normal condition and the

sound will disappear when you release the volume button (when you reach the desired volume level).

Radio operation

 Press the POWER ON/OFF button to turn on the unit.

 Press the FUNCTION button repeatedly until display shows “TUNER”

 Press the BAND button to select the desired radio band

 Press the STEREO/MONO/ID3 button on remote control to select the desired mode (FM

mono/stereo). In some places where reception is poor, it may be advisable to select MONO mode, to

improve clarity of radio signal.

Antenna

 For FM reception, adjust the FM antenna appropriately to obtain the best reception on the band

selected.

 The AM signal is picked up through the built-in antenna. The set should be placed to a proper

position for the best reception.

Manual frequency adjustment (scan mode)

Press NEXT or BACK buttons on the unit or BACK/TUNE DOWN or NEXT/TUNE UP buttons on the

RC to scan the radio frequency up or down by 1 step at a time. The display will indicate the exact

frequency at each step’s position. When a desired frequency or station is reached, it can be saved into one

of the memory positions (see Radio memory below).

Automatic frequency adjustment (seek mode)

Press and hold (for 2 seconds) the BACK  NEXT buttons to “seek” (automatically adjust) the radio

frequency up or down to the next available radio station. The radio digital display will indicate the exact

frequency of the next station that is found. When a desired station is reached it can be saved into one of

the “memory” positions (see “Radio memory” section).

Radio memory (station preset memory storage)

At any time the currently displayed station or frequency can be stored into one of the memory position.

Press PROGRAM button. Press MEM+/MEM- or PRESET+/PRESET- buttons on the RC to select

desired memory position (there are 10 memory positions for AM band and 10 positions for FM band).

Press PROGRAM button to save the selected station into the selected memory position. To recall any

saved memory, simply press MEM+/MEM- or PRESET+/PRESET- buttons, the saved radio-band will

be recalled. To clear the memory or any position, simply save a new station to the same memory

position.