Hyundai H-ALMO2-18H2/O Руководство по эксплуатации онлайн [14/52] 213909

14.

Electric air conditioner (split system)

NOTE

The FAN mode can not be used to control the temperature.

While in this mode, only steps 1Ў3 and 4 may be performed.

DRY Operation

1. Push the MODE button to select DRY.

2. Push the TEMP button to set the desired temperature from Ў Ў 17C to 30C.

3. Push the ON/OFF button, the OPERATION lamp lights and the air conditioner starts to operate

in DRY mode at LOW fan speed. Push the ON/OFF button again to stop this unit operation.

NOTE

Due to the dierence of the set temperature of the unit and

the actual indoor temperature, the Air Conditioner when in

DRY mode will automatically operate many times without

running the COOL and FAN mode.

TIMER Operation

Push TIMER ON button to set the auto- on time and TIMER OFF

button to set the auto-o time.

1. To set the starting time.

1.1 Push the TIMER ON button, then the remote controller shows

TIMER ON , the last set time for the starting operation and the

signal “h” will be shown on the DIGITAL DISPLAY area. You are now ready to reset the time to

START the operation.

1.2 Push the TIMER ON button again to set desired unit start time.

1.3 Aer setting the TIMER ON ,there will be a one-half second

delay before the remote controller transmits the signal to the air conditioner. Then, aer approxi-

mately another 2 seconds, the signal “h” disappears and the set temperature will re-appear on

the digital display.

2. To set the stopping time.

2.1 Push the TIMER OFF button and the remote controller will show TIMER OFF, the last set time

for the stopping operation and the signal “h” will be shown on the DIGITAL DISPLAY area. You are

now ready to reset the time of the STOP operation.

2.2 Push the TIMER OFF button again to set the time you want to stop the operation.

2.3 Aer setting the TIMER OFF ,there will be a one-half second delay before the remote control-

ler transmits the signal to the air conditioner. Then, aer approximately another 2 seconds, the

signal “h” disappears and the set temperature will re-appear on the digital display.