Leister MISTRAL (Мистраль) [4/8] Change of nozzles reflectors

Operating

• Equipment must be installed by a specialist.

• As required, push-fit appropriate nozzle or reflector.

• Reduce air flow as required by use of the air slide (5).

• Adjust hot-air temperature by use of the potentiometer (3).

• Switch on (2) and allow to warm up for about 5 min.

• Cool down the tool after use.

Change of nozzles/reflectors

• Before changing nozzles/reflectors, allow the tool to cool down, or use only

combination pliers.

• Do not touch hot nozzle/reflector and make sure to put it only on a heat resistant

surface, because of the fire hazard.

• The nozzles/reflectors are easily pushed onto the conical heater tube (8) and are

then secured by fastening the screw on the clamp.

• Only Leister nozzles/reflectors should be used.

OPERATION Leister MISTRAL