Gardena ErgoJet 3000 (09332-20) [22/356] Operation

Converting unit from vacuum

use to blower use:

1. Stop unit and unplug the extension cord.

2. Remove the elbow tube and collection bag.

3. Remove the vacuum tubes by releasing the latch on the vacuum

inlet cover and rotating the cover until the tubes are released

from the latches of the retaining posts.

4. Close the inlet cover and make sure it is latched closed.

5. Re-install the blower tube. Refer to FITTING THE BLOWER

TUBE for instructions on how to attach this item.

NOTE: A safety switch will prevent the unit from starting if the inlet

cover is not latched closed.

4. Operation

WARNING: Do not use the unit without the tubes or collection bag properly

attached to avoid flying debris and/or impeller contact which can cause serious

injury. Always wear gloves and use eye protection to prevent rocks or debris from

being blown or ricocheting into the eyes and face which can result in blindness or

serious injury.

Cables: Use only 1.00mm

size cable up to 40 metres length maximum.

Maximum rating:

1.00mm

size cable

3000 W

Mains cables and extensions are available from your local

approved service centre. Only use extension cables specifically

designed for outdoor use.

Connecting the unit –

cable lock/extension cables:

Loop the extension cable

and insert it into the cable lock

This prevents unintentional separation of the electrical connection.

Then connect it to the mains cable.

9332-20.960.01.indd 22 04.01.12 07:47