Philips GC9682/80 [8/30] English
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Philips GC9682/80 [8/30] English

Philips GC9682/80 [8/30] English
10
ENGLISH
8 Put the appliance back on a stable and even surface. Plug in the appliance and
switch it on (Fig. 19).
9 Wait for 5 minutes for the appliance to heat up.
10 Keep the steam trigger pressed continuously while you move the iron on a piece of
thick cloth for 3 minutes (Fig. 20).
Warning: hot, dirty water comes out of the soleplate.
11 Stop moving the iron when no more water comes out or when steam starts coming
out.
12 You can continue to use the appliance immediately. Otherwise unplug the appliance
after the descaling is completed.
Troubleshooting
This chapter summarises the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, visit
www.philips.com/support for a list of frequently asked questions or contact the
Consumer Care Centre in your country.
Problem Possible cause Solution
The ironing board
cover becomes
wet or there are
water droplets
on the garment
during ironing.
Steam has condensed on
the ironing board cover after
a long ironing session.
Replace the ironing board cover if
the foam material has worn out. You
can also add an extra layer of felt
material under the ironing board
cover to prevent condensation on
the ironing board. You can buy felt in
a fabric shop.
You have an ironing board
cover that is not designed
to cope with the high steam
rate of the appliance.
Put an extra layer of felt material
under the ironing board cover to
prevent condensation on the ironing
board. You can buy felt in a fabric
shop.
Water droplets
come out of the
soleplate.
The steam that was
still present in the hose
has cooled down and
condensed into water. This
causes water droplets to
come out of the soleplate.
Steam away from the garment for a
few seconds.
Steam and/or
water come out
from under the
EASY DE-CALC
knob.
The EASY DE-CALC knob is
not tightened properly.
Switch o the appliance and let the
appliance cool down for 2 hours.
Unscrew the EASY DE-CALC knob
and screw it back onto the appliance
properly. Note: Some water may
escape when you remove the knob.
The rubber sealing ring of
the EASY DE-CALC knob is
worn.
Contact an authorised Philips service
centre for a new EASY DE-CALC
knob.

Содержание

Похожие устройства

Скачать