Soundmax SM-SA1004 Orange [3/27] Precautions read first

Precautions: Read First!

If after reading the direction you feel uncomfortable about installing the amplifier in your car, or not

equipped or competent to do so, you should have the amplifier installed by an authorized installer.

It's your car!

Negative battery terminal must be disconnected before any electrical connections are made.

Be sure choosing a location that provides substantial ventilation for the amplifier.

The most preferred locations would be in your car's trunk, under the front seats or on the back wall of

a truck.

The location chosen should provide at least 2" of clearance above the amplifier for adequate

ventilation.

If the amplifier is to be mounted vertically be sure that it is in a place where adequate air will flow

along the length of its heat sink fins for cooling.

NEVER mount the amplifier up side down; this will cause the heat to rise back into the amplifier

causing thermal shutdown or possible permanent damage.

NEVER mount the amplifier in a location that is subject to direct sunlight or exposed to moisture.

Be sure to mount the amplifier to a strong, solid surface, which will not give way under the stress of a

sudden stop or accident.

Make sure that the mounting screws will not penetrate the gas tank, brake and fuel lines, wiring or

other critical parts of your car when installed.

NEVER operate the amplifier without the proper power and ground wire 10 gauge minimum.

NEVER operate the amplifier without proper fusing. Fuse holder must be located with in 0.5 meters

from the battery. This fuse is to protect the car not the electronics. In case of a short, the fuse will

blow instead of the wire burning up. Using other than the recommended fuse ratings at the battery

and at the amplifier may cause damage to the amplifier and will void your warranty.

Do not run wiring underneath or outside the car since exposure to the elements may cause the

insulation to deteriorate rapidly, resulting in short-circuits and/or intermittent operation. All cables

should be run beneath carpets and inside trim pieces.

To help minimize interference, it is best to run the power cables along the opposite side from the

audio cables.

Whenever wires pass through metal, rubber or plastic grommets must be used to prevent the mental

from wearing through the installation and causing a short.

Whenever possible, use cable ties, mounting clamps and similar wiring aids (available from an

electrical supply or auto parts store) Adding stress relief loops to wiring is also advisable to prevent

straining or breakage.

It is best to test the system before the amplifier is mounted and interior of car is reassembled.