Marta MT-1347 [8/11] Assemblage

8

 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have

been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

 Before you begin cleaning, remove from the floor smoldering and sharp objects that may damage the dust container.

 To avoid overloading the power supply, do not connect the product together with other high-powered appliances to the same power line.

 When you wrap the cord, hold the plug carefully.

 Make sure that ventilation holes are not blocked.

 Event of a blocked suction inlet of the vacuum cleaner hose or telescopic tube, immediately turn off the vacuum cleaner. Do not expose any loose objects to get into the device.

Before switching on again is necessary to eliminate the clog.

 To attach the hose to a vacuum cleaner, insert the connector into the hole for attaching the hose and push down until it clicks.

 To disconnect the hose, press the connector button and pull the handle.

 Insert the tube into one another.

 Insert the hose handle into the tube. To disconnect, turn parts and pull them in different directions.

 Connect one of the nozzles:

 Combined Floor / carpet brush

 Sofa brush

 Crevice nozzle

 Pull the cord and connect it to the network. Device is equipped with cord rewind system. For cord rewind push button, always hold the cord and plug to avoid any injuries.

 Suction power regulator is on the handle of the vacuum cleaner.

 To prevent motor overheating cleaner do not use vacuum cleaner continuously for more than 30 minutes and always take a break for at least 15 minutes.

 After cleaning: switch off the appliance by pressing On / Off button on vacuum cleaner housing. Disconnect the mains plug. By clicking rewind button, wait until the cord is fully

rewound onto the drum inside the unit.

 In case of overheating unplug the appliance, wait for 30 minutes, remove all possible obstacles in ingoing airflow holes, then switch on again. The device is ready. If the problem

persists, contact the service center.