Netgear WNR2200 — manual Setup Guide for Your Wireless Router [18/41]

Превью страниц Страница 18 / 41

Installing Your Wireless Router Manually (Advanced and Linux Users) 15

• LAN. At least one LAN light (1) should be lit. Green indicates that your computer is

communicating at 100 Mbps; amber indicates 10 Mbps. If a LAN light is not lit, check that the

Ethernet cable from the computer to the router is securely attached at both ends, and that the

computer is turned on.

• USB. The USB light (3) should be lit if a USB device is connected and ready to be used.

• WLAN On/Off. The Wireless Local Area Network (WLAN) button (5) turns the wireless

function on and off.

• WPS. The WPS button (6) turns the WPS function on and off. Be sure the WLAN button is

turned on before turning on the WPS button.

Setting Up Your Router for Internet Access

When configuring your wireless router manually, you must log in to your N300 wireless router to

set it up initially and to make any changes to your wireless router’s settings later.

To access your router:

1. Connect to the N300 wireless router by typing http://www.routerlogin.net in the address

field of your browser, and then press Enter.

The factory default state is reset when you use the Restore Factory Settings button.

See “Restoring the Default Password and Configuration Settings” on page 40 for

more information.

Figure 9

Connect to the N300 wireless router by typing any one of these three URLs in the

address field of your browser, then pressing Enter:

• http://www.routerlogin.net

•

http://www.routerlogin.com

• http://192.168.1.1