Levenhuk DTX 43 цифровая [3/27] Levenhuk dtx 43 digital magnifier

Levenhuk DTX 43 Digital Magnifier

Never, under any circumstances, look directly at the Sun, another bright source of light or at a laser

through this device, as this may cause PERMANENT RETINAL DAMAGE and may lead to BLINDNESS.

User Manual

Care and maintenance

To keep your magnifier in good condition, observe the following guidelines:

1. Read the instructions in this user's manual before attempting to use the unit.

2. Do not attempt to repair the magnifier or open its case. This product contains no user serviceable parts.

3. Keep the magnifier away from wet areas, rain, and other sources of liquids. Do not submerge the unit.

4. Always operate the magnifier in a place where the temperature is 0–45 °C (32–113 °F).

5. Always store the magnifier in a cool and dry place at normal room temperature.

6. Do not attempt to force any connector into the unit's USB and MicroSD ports. All appropriate connectors should fit easily

into the ports.

Magnifier functions

Loading battery

Please use the Li-ion battery to power the magnifier. Slightly push and pull the battery door latch to open the battery

compartment. Load the battery according to the polarities shown inside the battery compartment, and then snap close the

battery door.

Note: Remove the battery when it is not in use for a long period of time.

Charging the battery

Before using the magnifier, you must charge its battery.

1. Plug the miniUSB connector of the USB cable into the miniUSB port located on the right side of the magnifier. Then plug the

USB connector of the USB cable into the port on the power adaptor, and next plug the power adaptor into a standard AC outlet.

2. When the battery gets charged, the LED indicator turns off. Unplug the magnifier.

3. You can now use your magnifier for up to two hours of continuous use. When the battery is low, the low-power indicator will

blink on the right down corner of the screen. Then you have to connect the power adaptor and plug it in to recharge the battery.

Note: Always turn the magnifier off during charging. The battery will not charge if the magnifier is left on.