Makita UT1400 Инструкция по эксплуатации онлайн [5/80] 257181

18. Hold power tool by insulated gripping surfaces, when performing an operation

where the cutting accessory may contact hidden wiring or its own cord.

Cutting accessory contacting a “live” wire may make exposed metal parts of

the power tool “live” and could give the operator an electric shock.

Operating the machine

Wrong use may result in damages. Therefore, the following instructions shall

always be observed:

Use stirrers recommended by the manufacturer (maximum diameter: 120 mm

(UT1200), 140 mm (UT1400) with M14 thread).

Do not overload the machine in a way that causes a standstill.

Tool change

Caution!

Do always remove the power plug before carrying out any work on the tool.

You may catch your fingers when inserting the tool. Therefore, do always wear

protective gloves when changing tools.

The work spindle of the tool is provided with a M14 internal thread.

Keep thread and front surfaces clean. Do use a SW 22 spanner to remove the

stirrer and to hold up the work spindle.

Switching the machine on and off

Short-Time Operation

Starting the machine: Press on/off switch

Stopping the machine: Release on/off switch

Permanent Operation

Starting the machine: Press on/off switch and while keeping it pressed, engage

the lock button

Stopping the machine: Press on/off switch again and release it

The mixer has an electronic switch in order to regulate the speed level by

keystrokes.

It is recommended to only use it when the machine is started or stopped in order

to avoid splashing material. If the continuous mode is operated with reduced

speed, it leads to overstress because the machine is not provided with enough

cooling air and overheating will occur significantly faster.

Care and Maintenance

Repairs shall only be carried out by qualified staff trained and experienced in this

area. The tool shall be inspected by a skilled electrician after every repair. The

power tool is designed to require only a minimum of maintenance and care.

However, the following work shall be carried out and/or the following parts shall

be inspected regularly:

• Do always keep the power tool and the ventilation slots clean.

• Make sure that no foreign objects get into the power tool.

• If the tool breaks down, the repair shall only be carried out by an authorised

shop.