Qnap TS-131 [18/75] Chapter 2 power button and reset button behavior

Chapter 2. Power Button and Reset Button Behavior

 Power button: Press to turn on or turn off.

System

Power button

(Turn on)

Power button

(Hardware turn

off)

Power button

(Force turn off)

All models

Press once

1.5 sec

5 sec

 Reset button: Press to reset the system settings.

System

Basic system reset

(1 beep)

Advanced system reset

(2 beeps)

All models

3 sec

10 sec

Basic system reset (3 sec)

Press the reset button for 3 seconds, a beep sound will be heard. The following settings are

reset to default:

 System administration password: admin

 TCP/IP configuration: Obtain IP address settings automatically via DHCP

 TCP/IP configuration: Disable Jumbo Frame

 TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port

trunking mode will be reset to “Active Backup (Failover)”.

 System Port: 8080 (system service port)

 Security Level: Low (Allow all connections)

 LCD panel password: (blank)*

 VLAN will be disabled

*This feature is only provided by the NAS models with LCD panels. Please visit

http://www.qnap.com for details.

Advanced system reset (10 sec)

Press the reset button for 10 seconds; you will hear two beeps at the third and the tenth

seconds. The NAS will reset all the system settings to default as it does by web-based

system reset in “Administration” > “Restore to Factory Default” except all the data are

reserved. The settings such as the users, user groups, and the network share folders

previously created will be cleared. To retrieve the old data after the advanced system reset,

create the same network share folders on the NAS and the data will be accessible again.