Freggia WIE148 [11/36] Control panel

The LED turns on. During the wash program in progress, the cycle can be stopped by pressing the

START/PAUSE button for a couple of seconds.

At this point, the wash program stops and you can make changes to the wash options (enabled

depending on which stage of the wash cycle you are in). If the water temperature is below 50°C,

the door can be opened (about 2 minutes after enabling the pause function) to load/empty any

laundry. To re-enable the wash phase press the START/PAUSE button again.

N.B. if, during a pause, no operation is carried out, the wash phase will restart automatically after

5 minutes.

• CONTROL LOCK child safety lock

To activate the control panel lock, simultaneously press the B-E (lock symbol) buttons; three horizontal lines will

appear on the display.

If, during the wash cycle or at the end of the cycle, you wish to reactivate the controls, press buttons B-E simultaneously,

until the three horizontal lines disappear.

• DISINFECTING THE DRUM 90°

Frequent washes at low temperatures may encourage the formation of mildew and unpleasant odours inside the

washing machine. The DRUM DISINFECTION function thoroughly cleans the machine with a special cycle at 90°C.

DRUM DISINFECTION automatically recommends, through the blinking of the abbreviation

on the display, that

you start the cleaning program after a certain number of washes, if high temperature cycles have not been selected

during the period.

Remove all laundry from the drum, put the knob I on the DRUM DISINFECTION program and press the start H button

to start the cycle. The DRUM DISINFECTION program can be performed at any time or when conditions require it.

Empty the washing machine drum and close the door. Put the knob I on the DRUM DISINFECTION program, keep the

button ( ) pressed until the abbreviation appears on the display. Press H to start the DRUM DISINFECTION cycle.

• EASY LOGIC

The EASY LOGIC automatically adjusts washing time, water and energy consumption based on the actual amount of

laundry loaded in the machine.

The 1/2 load function is unnecessary as the EASY LOGIC system automatically sets the wash parameters.

CONTROL PANEL