Pioneer VSX-920K Инструкция по эксплуатации онлайн [113/400] 2748
![Pioneer VSX-920K Инструкция по эксплуатации онлайн [113/400] 2748](/views2/1003088/page113/bg71.png)
Additional information 12
113
En
English
Français
Deutsch
Nederlands
Italiano
Español
Settings
Symptom Remedy
The Auto MCACC Setup
continually shows an error.
• The ambient noise level may be too high. Keep the noise level in the room as
low as possible (see also Problems when using the Auto MCACC Setup on
page 42). If the noise level cannot be kept low enough, you will have to set up
the surround sound manually (page 100).
• When using only one surround back speaker, connect it to the SURROUND
BACK L (Single) terminals.
• To use a 5.1-channel speaker set, use the surround speakers for the surround
channel, not the surround back channel.
• Make sure there are no obstacles between the speakers and the microphone.
• If Reverse Phase is displayed, try the following:
– The speaker’s wiring (+ and –) may be inverted. Check the speaker
connections.
– Depending on the type of speakers and their installation conditions, Reverse
Phase may be displayed even if the speakers are properly connected. If this
happens, select GO NEXT and continue.
– If the speaker is not pointed to the microphone (listening position) or when
using speakers that affect the phase (dipole speakers, reflective speakers, etc.),
it may not be possible to properly identify the polarity.
After using the Auto MCACC
Setup, the speaker size
setting is incorrect.
• There may have been some low frequency noise in the room from an air-
conditioner, motor, etc. Switch off all other appliances in the room and use
Auto MCACC Setup again.
• Depending on a number of factors (bass reproduction capabilities of the
speakers, room size, speaker placement, etc.) this may occur in some cases.
Change the speaker setting manually in Speaker Setting on page 102, and use
the ALL (Keep SP System) option for the Auto MCACC menu in Automatic
MCACC (Expert) on page 87 if this is a recurring problem.
Can’t adjust the Fine Speaker
Distance setting (page 91)
properly.
• Check that the speakers are all in phase (make sure the positive (+) and
negative (–) terminals are matched up properly).
The display shows KEY LOCK
ON when you try to make
settings.
• With the receiver in standby, press STANDBY/ON for about 10 seconds
while holding down SPEAKERS to disable the key lock.
Most recent settings have
been erased.
• The power cord was disconnected from the wall while adjusting this setting.
• Settings are only stored if all the zones are turned off. Turn off all the zones
before unplugging the power cord.
The various system settings
are not stored.
• Do not pull out the power cord while conducting the settings. (The settings
will be stored when both the main zone and sub zone turn off. Turn off all zones
before pulling out the power cord.)
VSX-1020_SYXCN.book 113 ページ 2010年3月12日 金曜日 午前9時10分
Содержание
- Contents 4
- Adjusting the sound and picture quality as desired 7
- Basic playback page 44 7
- Before you start 7
- Changing the osd display language osd language page 39 7
- Connecting the components 7
- Connecting the speakers 7
- Determining the speakers application page 17 7
- Flow of settings on the receiver 7
- Making maximum use of the remote control 7
- Mcacc speaker settings 7
- Other optional adjustments and settings 7
- Power on 7
- The input setup menu page 42 7
- Before you start 8
- Caution 8
- Checking what s in the box 8
- Installing the receiver 8
- Loading the batteries 8
- Character display 9
- Controls and displays 9
- Front panel 9
- Indicators 9
- Input selector dial 9
- Multi zone controls 9
- Remote sensor 9
- Speakers 9
- U standby on 9
- Ipod iphone direct control 10
- Ipod iphone usb terminals 10
- Listening mode buttons 10
- Master volume dial 10
- Mcacc setup mic jack 10
- Phones jack 10
- Tuner controls 10
- Vsx 1020 vsx 1025 only hdmi input connector 10
- Vsx 920 only video 2 input terminals 10
- Digital format indicators 11
- Display 11
- Listening mode indicators 11
- Multi zone 11
- Phase control 11
- Program format indicators 11
- S rtrv 11
- Signal indicators 11
- Analog signal indicators 12
- Character display 12
- Input function indicators 12
- Master volume level 12
- Matrix decoding format indicators 12
- Remote control mode indicator 12
- Scroll indicators 12
- Speaker indicators 12
- Tuner indicators 12
- Input function buttons 13
- Multi operation use to perform multi operations page 81 13
- Receiver controls 13
- Remote control 13
- Tv control buttons 13
- U receiver 13
- Zone 2 13
- I j k l enter 14
- Listening mode controls 14
- Master volume 14
- Operating range of remote control unit 14
- Receiver controls 14
- Remote control led 14
- Tv ctrl 14
- Connecting your equipment 15
- Important 15
- Rear panel 15
- Caution 16
- Important 16
- A 9 channel surround system front height 17
- B 9 channel surround system front wide 17
- C 7 channel surround system speaker b connection 17
- Determining the speakers application 17
- D 5 channel surround system front bi amping connection high quality surround 18
- E 5 channel surround system zone 2 connection multi zone 18
- Important 18
- Other speaker connections 18
- Placing the speakers 19
- Some tips for improving sound quality 19
- Bare wire connections 20
- Caution 20
- Connecting the speakers 20
- Loosen terminal and insert exposed wire 20
- Push open the tabs and insert exposed wire 20
- Release the tabs 20
- Tighten terminal 20
- Twist exposed wire strands together 20
Похожие устройства
- Behringer MIX 800 MINIMIX Инструкция по эксплуатации
- Astralux 650 (mini) Инструкция по эксплуатации
- Miele FN 4957 S ed-1 Инструкция по эксплуатации
- Asus SDRW-08D1S-U White Инструкция по эксплуатации
- Dremel 300SJ F0130300SJ Инструкция по эксплуатации
- Pioneer VSX-420K Инструкция по эксплуатации
- Behringer PB1000 PEDAL BOARD Инструкция по эксплуатации
- Astralux 9710 Инструкция по эксплуатации
- Miele F 9252 i Инструкция по эксплуатации
- Dremel Big On Detail Drem F0130300LS Инструкция по эксплуатации
- Asus SDRW-08D1S Инструкция по эксплуатации
- Sony STR-DH510 Инструкция по эксплуатации
- Hyundai ix55 Veracruz Инструкция по эксплуатации
- Dremel 300 JC (25 насадок) F0130300JC Инструкция по эксплуатации
- Astralux 690 Инструкция по эксплуатации
- Miele F 9212 i Инструкция по эксплуатации
- Asus 08D2S-U Black Инструкция по эксплуатации
- Hyundai ix35 Инструкция по эксплуатации
- Behringer PB600 PEDAL BOARD Инструкция по эксплуатации
- Dremel 300-1/55 F0130300JF Инструкция по эксплуатации
Скачать
Случайные обсуждения