Vitek VT-6401 [5/42] English

English

Installation of batteries into remote sensor

1. Turn off the screws on the batteries compartment.

2. Select data transfer channel by channels switcher «1-2-».

. Install 2 batteries (“ААА”, 1.5 V), following polarity.

4. Close battery compartment cover and turn up the screws.

Connecting AC-power adapter to basic block/ Installation of batteries

into basic block. Connect AC-power adapter (6,0V; DC) to basic block

through the jack for an external power source located below the batteries

compartment.

2. Open the cover of batteries compartment.

. Install three batteries (“AАА”, 1.5 V), following polarity.

4. Close battery compartment cover.

Note:

Basic block is intended for power supply from external source, batteries are

used as reserve power source.

Replacing Batteries

On appearance of adequate icon indications displaying that the batteries are

down replace remote sensor batteries.

Get Started

By first startup, switch main block on, and switch on remote sensor. Set data

transfer channel by channel switcher «1-2-» located on remote sensor. Hold

button CHANNEL on main block, you will hear sound signal. Main block starts

searching remote sensor signal. Pres button Тх to reset the sensor. When con-

nection between sensor and main block is set on, temperature and humidity

indications from remote sensor will appear on LCD.

Setting pressure parameters by switching on the unit first time

1. After connecting basic block to power supply line pressure units’ icon starts

blinking. Use buttons «▼/▲»to select pressure units, inHg, hPa, mBar or

mmHg. Press button PRESSURE for confirmation.

2. Use buttons «▼/▲» to set the value of altitude above sea level. Press button

PRESSURE for confirmation.

Setting pressure parameters via first startup is imperative for precise

weather forecast.

6401IM.indd 5 07.04.2008 12:35:47