![Alto-Shaam AR-7H [4/32] N o t e](/img/pdf.png)
Alto-Shaam AR-7H [4/32] N o t e
![Alto-Shaam AR-7H [4/32] N o t e](/views2/1318344/page4/bg4.png)
MN-28953 (Rev 0) • 09/13 • AR-7H Hot Holding Rotisserie Companion Operation & Care Manual • 2
CAUTION
Used to indicate the presence of a hazard that
can or will cause minor personal injury, property
damage, or a potential unsafe practice if the
warning included with this symbol is ignored.
CAUTION
Used to indicate the presence of a
hazard that can or will cause minor or
moderate personal injury or property
damage if the warning included with
this symbol is ignored.
DANGER
Used to indicate the presence of
a hazard that WILL cause severe
personal injury, death, or substantial
property damage if the warning
included with this symbol is ignored.
WARNING
Used to indicate the presence of
a hazard that CAN cause personal
injury, possible death, or major
property damage if the warning
included with this symbol is ignored.
1. This appliance is intended to cook, hold
or process foods for the purpose of human
consumption. No other use for this appliance is
authorized or recommended.
2. This appliance is intended for use in commercial
establishments where all operators are
familiar with the purpose, limitations, and
associated hazards of this appliance. Operating
instructions and warnings must be read and
understood by all operators and users.
3. Any troubleshooting guides, component views,
and parts lists included in this manual are for
general reference only and are intended for use
by qualified technical personnel.
4. This manual should be considered a permanent
part of this appliance. This manual and all
supplied instructions, diagrams, schematics,
parts lists, notices, and labels must remain with
the appliance if the item is sold or moved to
another location.
NOTE: Used to notify personnel of
installation, operation, or
maintenance information that is
important but not hazard related.
SAFETY PROCEDURES
AND PRECAUTIONS
Knowledge of proper procedures is essential to the
safe operation of electrically and/or gas energized
equipment. In accordance with generally accepted
product safety labeling guidelines for potential
hazards, the following signal words and symbols
may be used throughout this manual.
NOTE
For equipment delivered for use
in any location regulated by the
following directive:
DO NOT DISPOSE OF ELECTRICAL
OR ELECTRONIC EQUIPMENT WITH
OTHER MUNICIPAL WASTE.
Содержание
- Hot holding rotisserie companion 1
- Installation 1
- Maintenance 1
- Models 1
- Operation operation 1
- Untitled 2
- D e l ive r y 3
- Unpack ing 3
- C a u ti on 4
- Da n g er 4
- Do not dispose of electrical or electronic equipment with other municipal waste 4
- For equipment delivered for use in any location regulated by the following directive 4
- N o t e 4
- Safety procedures and precautions 4
- Wa rn i ng 4
- C a u t io n 5
- Ca u ti o n 5
- D a n ger 5
- D ang e r 5
- Ins t a l l ation 5
- Leveling 5
- Minimum clearance requirements 5
- S i te ins t a l l a ti o n 5
- 1 16 816mm 6
- 1 2 1028mm 6
- 1 2 646mm 6
- 1 4 869mm 6
- 1 8 942mm 6
- 1 8 968mm 6
- 7 16 824mm 6
- Chicken boats up to 24 6 per shelf 6
- Electrical connection 6
- Full size sheet pans eight 8 18 x 26 x 1 457mm x 660mm x 25mm half size sheet pans up to sixteen 16 18 x 13 x 1 457mm x 330mm x 25mm 6
- In s ta lla t i o n 6
- Lbs 27 kg 6
- Maximum 6
- Mn 28953 rev 0 09 13 ar 7h hot holding rotisserie companion operation care manual 4 6
- Product pan capacity 6
- S it e ins t a l l a ti o n 6
- Side view front view side view 6
- Single pane flat glass door double pane curved glass door 6
- D a n ger 7
- D a nge r 7
- E l e c t r ic a l c o n n e c ti o n 7
- Ensure power source matches voltage identified on appliance rating tag 7
- Ins t a l l ation 7
- C a u t i o n 8
- C au t i o n 8
- Each of the four holes 8
- In s ta lla t i o n 8
- Make certain to fasten 8
- S t ac k ing c o m b i n a ti o n s ins t al lat ion re quire ment s 8
- Stacking applications outside the u s require flanged feet and must be bolted to the floor 8
- Ins t a l l ation 9
- S t ac k ing i n s tr u c ti o n s 9
- A r 7h o pt ions acce s s ories 10
- D a n g e r 10
- Description part number 10
- In s ta lla t i o n 10
- Op e ra t in g ins t ructio ns 10
- Severe damage or electrical hazard could result 10
- Start up 10
- Heating procedure 11
- Manual control identification 11
- Op e ra t in g ins t ruct io ns 11
- Thermostat and heat light sequence 11
- Thermostat calibration 11
- Calibration instructions 12
- Control lock 12
- Electronic control identification 12
- Enable disable beeper 12
- Fahrenheit celsius 12
- Heating procedure 12
- O p e r a t i n g i n s t r uct ion s 12
- On off key 12
- Up down arrow key 12
- Chefs cooks and other specialized food service personnel employ varied methods of cooking proper holding temperatures for a specific food product must be based on the moisture content of the product product density volume and proper serving temperatures safe holding temperatures must also be correlated with palatability in determining the length of holding time for a specific product 13
- General holding guidelines 13
- Halo heat maintains the maximum amount of product moisture content without the addition of water water vapor or steam maintaining maximum natural product moisture preserves the natural flavor of the product and provides a more genuine taste in addition to product moisture retention the gentle properties of halo heat maintain a consistent temperature throughout the cabinet without the necessity of a heat distribution fan thereby preventing further moisture loss due to evaporation or dehydration 13
- If the unit is equipped with a thermostat indicating a range of between 1 and 10 use a metal stemmed indicating thermometer to measure the internal temperature of the product s being held adjust the thermostat setting to achieve the best overall setting based on internal product temperature 13
- In an enclosed holding environment too much moisture content is a condition which can be relieved a product achieving extremely high temperatures in preparation must be allowed to decrease in temperature before being placed in a controlled holding atmosphere if the product is not allowed to decrease in temperature excessive condensation will form increasing the moisture content on the outside of the product to preserve the safety and quality of freshly cooked foods however a maximum of 1 to 2 minutes must be the only time period allowed for the initial heat to be released from the product 13
- Mn 28953 rev 0 09 13 ar 7h hot holding rotisserie companion operation care manual 11 13
- Most halo heat holding equipment is provided with a thermostat control between 60 and 200 f 16 to 93 c if the unit is equipped with vents close the vents for moist holding and open the vents for crisp holding 13
- Op e ra t in g ins t ruct io ns 13
- San ita t i o n 14
- C a r e a n d cl e a ning 15
- C a u t i o n 15
- C l e a n i n g a n d p r e v e n t a t i ve m ai n t en an c e 15
- Always follow appropriate state or local health hygiene regulations regarding all applicable cleaning and sanitation requirements for equipment 16
- At no time should the interior or exterior be steam cleaned hosed down or flooded with water or liquid solution of any kind do not use water jet to clean 16
- C a r e a n d c le a n i ng 16
- C a u t i o n 16
- C a u t io n 16
- D a n g e r 16
- D a nge r 16
- Warranty becomes void if appliance is flooded 16
- Code description possible cause 17
- Mn 28953 rev 0 09 13 ar 7h hot holding rotisserie companion operation care manual 15 17
- S e rvice 17
- T r ou b l e s h o o ti n g g u i d e e lect ronic cont rol 17
- To test probe and air sensor 17
- Ca u ti o n 18
- Cleaning or servicing 18
- D a n g e r 18
- Disconnect unit from 18
- Power source before 18
- Se r v ic e 18
- C u r v e d d o o r s h o w 19
- Fu l l a s s e m b l y s e r v i c e vie w 19
- Mn 28953 rev 0 09 13 ar 7h hot holding rotisserie companion operation care manual 17 19
- S e rvice 19
- Do or a s s e m b l y 20
- I n t e r ior s e r v i c e v i e w 20
- Mn 28953 rev 0 09 13 ar 7h hot holding rotisserie companion operation care manual 18 20
- Se r v ic e 20
- Do ub l e p a n e c u r v e d g las s d oor 21
- Door replacement 21
- S e rvice 21
- War n i n g 21
- Door replacement 22
- S ing l e p a n e f l a t g l a s s d oor 22
- Se r v ic e 22
- War n i n g 22
- Back replacement 23
- Mn 28953 rev 0 09 13 ar 7h hot holding rotisserie companion operation care manual 21 23
- S e rvice 23
- Sta inl e s s s te e l b a c k p anel 23
- Step 1 remove rear door rubber gasket hinges and 28 screws from gasket channel 23
- Step 2 attach inner back panel with 24 sc 25849 23
- Step 3 insert in 2003 into outer back panel 23
- Step 4 attach outer back panel with 4 sc 27843 23
- Step 5 attach 4 spacer brackets with 2 each sc 2459 23
- Step 6 attach 2 hinge cover plates with 4 each sc 23151 23
- El e c t r ic a l m a n u a l c o nt rol 24
- Mn 28953 rev 0 09 13 ar 7h hot holding rotisserie companion operation care manual 22 24
- Se r v ic e 24
- El e c t r ic a l e l e c tr o nic cont rol 25
- Mn 28953 rev 0 09 13 ar 7h hot holding rotisserie companion operation care manual 23 25
- S e rvice 25
- All alto shaam equipment is sold f o b shipping point and when accepted by the carrier such shipments become the property of the consignee should damage occur in shipment it is a matter between the carrier and the consignee in such cases the carrier is assumed to be responsible for the safe delivery of the merchandise unless negligence can be established on the part of the shipper 1 make an immediate inspection while the equipment is still in the truck or immediately after it is moved to the receiving area do not wait until after the material is moved to a storage area 2 do not sign a delivery receipt or a freight bill until you have made a proper count and inspection of all merchandise received 3 note all damage to packages directly on the carrier s delivery receipt 4 make certain the driver signs this receipt if he refuses to sign make a notation of this refusal on the receipt 5 if the driver refuses to allow inspection write the following on the delivery receipt driver refuses to al 32
- Date installed 32
- Fax 262 51 067 800 29 744 32
- Limited warranty 32
- Phone 262 51 800 800 58 8744 32
- Purchased from ___________________________________________ serial number 32
- Transportation damage and claims 32
- Voltage 32
- We will continue our policy of assisting our customers in collecting claims which have been properly filed and actively pursued we cannot however file any damage claims for you assume the responsibility of any claims or accept deductions in payment for such claims 32
- Www alto shaam com 32
Похожие устройства
- Alto-Shaam AR-7H Спецификация
- Sikom МК-8.16 Инструкция по эксплуатации
- Sikom РК-1.1 Инструкция по эксплуатации
- ATESY БА-2/5 "Масленица" Инструкция по эксплуатации
- ATESY БА-2/5 "Масленица" Сертификат
- ATESY БА-2/5 "Масленица" Декларация о соответствии
- ATESY БА-2/5 "Масленица" Каталог оборудования фаст-фуд ATESY
- ATESY Гольфстрим-1/1М-2 Инструкция по эксплуатации
- ATESY Гольфстрим-1/1М-2 Каталог оборудования фаст-фуд ATESY
- ATESY Гольфстрим-1/1М-2 Сертификат
- ATESY Гольфстрим-1/1М-2 Декларация о соответствии
- Winterhalter UC-L (003V0048) с дозаторами Инструкция по эксплуатации
- ГродТоргМаш МПФ-30-01 "КОТРА" Инструкция по эксплуатации
- Elframo LP 70 Инструкция по эксплуатации
- Elframo LP 70 Каталог оборудования Elframo (англ.)
- Elframo LP 61 H Инструкция по эксплуатации
- Elframo LP 61 H Каталог оборудования Elframo (англ.)
- Elframo LP 130 Инструкция по эксплуатации
- Elframo LP 130 Каталог оборудования Elframo (англ.)
- SAP SM155 A Инструкция по эксплуатации